Toshiba 24V4210U 用户手册

52

Highlight ANT/CABLE In and press the ( /  arrow) buttons 
to select the input source (Cable or Antenna).

To save your new settings, highlight Done, and then press the 
OK button. To revert to your original settings, highlight 
Cancel, and then press the OK button. 

To make sure your TV stops only on the channels you want when 
you press the CH Up/Down arrow buttons on the remote control or 
the control panel, store those channels in the TV’s memory.

You can configure the TV to detect all active channels in your area 
and store them in its memory. Then you can manually store or skip 
individual channels from memory.

❖

You must configure the antenna/cable input source first.

❖

The automatic channel programming process will erase 
channels that were previously programmed into the TV’s 
memory.

❖

To tune the TV to a channel not programmed in the channel 
memory, you must use the Channel Number buttons on the 
remote control.

❖

Programming channels when the ANT/CABLE input is 
configured for Cable will take substantially longer than when the 
antenna input is configured for Antenna. This is normal; 
however, once channel programming is finished, you should not 
have to repeat the programming process again unless your 
Cable TV service lineup changes significantly.

To program channels automatically:

Configure the antenna input source, if you have not already 
done, see 

.

Press the MENU button to open the Setup menu.