Toshiba DK40I 用户手册

6. For BRI and PRI, run Program *42 to assign the PRI or BRI, or T1, circuits to be used for 

Primary and Secondary Clock Source. To enter the program, enter the card slot number 
followed by the circuit number. When using the RPTU PRI or RDTU T1 interface then the 
circuit number is always 1.

7. For BRI and PRI, run Program *63 to assign the timer for sending dialed digits. Also use this 

program to enable sub-address dialing. (*63-1 is not zero).

8. See the following section, 

, and make the appropriate programming 

assignments.

♦

Program 10-1–System Assignments: LED 16 determines the initialization process for BRI 
lines connected to the ISDN network (see 

).

♦

Program 10-4–ACD/ISDN Parameters: LEDs 11 and 12 set the T-Wait ISDN PRI and BRI 
timers, respectively. T-wait timers are used for reducting overloading ISDN terminals during 
concurrent initialization, such as following a wide-area power failure. LED 09 enables Listed 
Directory Number (LDN) Registration for an unknown number in an unknown numbering 
plan. LED 13 specifies whether or not 3.1 kHz audio calls can be received as speech calls. 
LED 14 enables the ISDN “Start” code to be sent when the Speed Dial button is pressed (see 

♦

Program 39–Telephone Feature Buttons  and  Program 59–Attendant Console Feature 
Buttons: A new button is provided called the 

6WDUW

 button in both Program 39 (see 

) and 59 (see 

) to defeat the timeout when dialing is complete. Also a 

6XE

 

button is provided for entering sub-address information.

♦

Programs 55-1 and 55-2–Least Cost Routing Modified Digits: Enables a sub-address 
separator (see 

♦

Program 30 – Station Class of Service: LED 12 defines whether the 

 button is used for 

dialing a sub-address or as a dialing separator. When LED 12 is On, only the standard stations 
are affected. The DKT and EKT ports are ignored (see 

If the first dialed digit is 

, the 

will be treated as a feature access code. If 

is entered at any 

point after that (in other words, as long as it is not the first digit dialed), then the system will 
treat the following numbers as a subaddress. A second 

should then be entered to indicate the 

end of the subaddress.