Toshiba DK40I 用户手册
ISD
N
ISDN
Program *66-3 – Channel Group/Trunk Parameters
Strata DK Programming 5/00
7-31
Program *66-3 – Channel Group/Trunk Parameters
Processor Type:
DK40i, all RCTUs (Release 4.0 or higher) and BCUs
Program Type:
Trunk, PRI
Initialized Default:
LEDs 1, 2 and 12 On; all other LEDs Off
LEDs 03~06 specify the trunk types shown in the following table.
Program *66-3 Overview
This program assigns ISDN CO switch type and special call treatment for the ISDN service. Call
treatment includes whether or not operator calls are allowed, if carrier access is allowed, etc. The
ISDN service is similar to trunk type, such as POTS, FX, Tie, outWATS and inWATS.
treatment includes whether or not operator calls are allowed, if carrier access is allowed, etc. The
ISDN service is similar to trunk type, such as POTS, FX, Tie, outWATS and inWATS.
LEDs 11, 13, 14, 15: Programming for ISDN CO Switch Type
Determine which type of CO switch is providing the PRI service and set the following programs
accordingly. (This is not necessary for Basic Rate Interface (BRI) service.) Most Northern
Telecom DMS ISDN switches follow Northern Telecom’s PRI custom protocol, sometimes
referred to as National ISDN Stardard 1 (NI1). However, some DMS ISDN switches are National
ISDN Stardard 2 (NI2). Most all ISDN switches manufactured by other companies follow the NI2
standard.
accordingly. (This is not necessary for Basic Rate Interface (BRI) service.) Most Northern
Telecom DMS ISDN switches follow Northern Telecom’s PRI custom protocol, sometimes
referred to as National ISDN Stardard 1 (NI1). However, some DMS ISDN switches are National
ISDN Stardard 2 (NI2). Most all ISDN switches manufactured by other companies follow the NI2
standard.
✱ ✱ ✱ ✱ 6SNU ✱ +ROG 6SNU
+ROG 6SNU +ROG 6SNU +ROG
LEDs
POTS
FX
Tie
(senderized)
Tie
(cutthrough)
OutWATS
(IntraLATA)
OutWATS
(InterLATA)
InWATS
03
On
On
On
04
On
On
On
On
05
On
06
On
On
LEDs
Setting
Trunk Groups
1
2
3
4
5
6
7
8
9
10 11 12 13 14 15 16
01
On: Operator calls allowed.
Off: Not allowed.
Off: Not allowed.
02
On: Carrier Access allowed.
Off: Not allowed.
Off: Not allowed.
03
Trunk Group Type (see above table).
04
Trunk Group Type (see above table).
05
Trunk Group Type (see above table).
06
Trunk Group Type (see above table).
07~10
Not Used.
11
On: ISDN Call Number/Type Unknown.
Off: Standard Called Party Number Type.
(Default Off)
Off: Standard Called Party Number Type.
(Default Off)
12
On: DK sends Ringback Tone to Network.
Off: No RBT to Network.
Off: No RBT to Network.
13~15
On: DMS Custom CO switch
Off: NI2-CO switch (Default is Off)
Off: NI2-CO switch (Default is Off)
DATA = Light LEDS to assign
features. See tables below.
features. See tables below.
SEL = 3
Enter the ISDN Trunk
Group Number (01~16)
Group Number (01~16)