Toshiba DK40I 用户手册

System & Station

Program *03 for DK424 – Cabinet Type Identification

3-12

Strata DK Programming 5/00

Program *03 for DK424 – Cabinet Type Identification

Processor Type:

RCTUE/F or B5CAU/B5CBU

Program Type:

System

Initialized Default:

All cabinets = 1

Program *03 - Overview

You must run this program when using the DK424 or DK280 RCTUE/F, or DK424i B5CAU/BU.
It identifies which type of cabinets are installed (DK424i, DK424 or DK280).

The RCTUE/F processor can be installed in a DK424 or DK280 base cabinet. The expansion
cabinets can be any combination of DK424 and DK280 - except the seventh expansion cabinet
must be a DK424.

The DK280 expansion cabinet can only support six universal PCB slots in any possible
configuration.

The DK424 expansion cabinet supports eight universal PCB slots only if the RCTUE/F is installed
in a DK424 base cabinet and the MBJU jumper is removed from the DK424 base cabinet
backplane. MBJU does not apply with DK424i cabinets.

Important!

This programs exists on DK424i B5CAU/BU processors. It must always be set to
Cabinet Type “1” allowing 10 slots for each DK424i Expansion Cabinet. DK280
and DK424 Expansion Cabinets cannot be used with DK424i processors.

✱ ✱ ✱ ✱ 6SNU ✱ +ROG 6SNU

+ROG 6SNU +ROG 6SNU +ROG

SELECT =

(Cabinet No. 1~7)

Cabinet Type

(1 or 2)

1 (Base)

2 (1st Expansion)

3 (2nd Expansion)

4 (3rd Expansion)

5 (4th Expansion)

6 (5th Expansion)

7 (6th Expansion)

1 only

SELECT = Cabinet No. (1~7)

CABINET = 1 or 2 (type)
Type 1 (DK424 or DK424i)
Type 2 (DK280)

Turn System Power Off (5 sec) then On.

or...

Run Program 91-2

Expansion Cabinet Universal PCB Slot Availability

Case 1

RCTUE/F in DK424 Base Cabinet with MBJU removed

Note

MBJU is not used with DK424i cabinets.

Case 2
RCTUE/F in DK280 Base Cabinet

Expansion Cabinet (max 6)

Universal PCB Slots

DK424

1~8 available

DK280

1~6 available

Expansion Cabinet (max 5)

Universal PCB Slots

DK424

1~6 available

DK280

1~6 available