Wegener Communications 562 用户手册
Operation
24
800092-01 Rev. A
www.wegener.com
LAN IP Networking
Carrier Settings
Terminal options
User Relay
Date and Time information
Unit Label settings
Switch Application
Set Video Decoder options
Set Decoder Options
Use following steps to display
Decoder Setup
screen on the OSD menu:
1. Navigate to the Unit Setup screen, see
2. Press the down arrow button to select
Decoder Setup
.
3. View the details as shown in
Figure 3.13: iPump 562 OSD Decoder Setup
Use the
Decoder Setup
screen to set and display the decoder options.
Table 3.7: Video Decoder Options
Option
Possible values
Comments
Decoder Source
Follow Tune (currently selected
RF source and program #) or Off
(no A/V output)
RF source and program #) or Off
(no A/V output)
Controls source of input transport stream for the
primary A/V decoder to play. The source can be either
Multicast UDP from Satellite/RF or Multi/Unicast UDP
from LAN/ETHERNET
primary A/V decoder to play. The source can be either
Multicast UDP from Satellite/RF or Multi/Unicast UDP
from LAN/ETHERNET
TV Aspect Ratio
4x3 (Traditional TV) 16x9 (Wide
screen TV) 14x9 (CiniView II)
screen TV) 14x9 (CiniView II)
Allows the receiver to automatically correct a mismatch
in the aspect ratio of the TV to the content being
displayed.
in the aspect ratio of the TV to the content being
displayed.
Output Scaling
Letterbox (black bars either at
top/bottom or at sides), Pan/Scan
(display may be off screen)
top/bottom or at sides), Pan/Scan
(display may be off screen)
Optimizes viewing quality if the content does not match
the TV Aspect Ratio. In Pan/Scan mode, improvement
in viewing experience depends on the source content.
the TV Aspect Ratio. In Pan/Scan mode, improvement
in viewing experience depends on the source content.
Closed Captioning
PASSTHRU (ntsc/pal) or CC1:4
(EIA-608) orDTV (EIA-708-B)
(EIA-608) orDTV (EIA-708-B)
Sets the option to render subtitling information in
different formats including Divicom.
different formats including Divicom.