Teledyne 200AH 用户手册
Teledyne API Model 200AH NO
X
Analyzer Instruction Manual, 06492, Rev. G2
9-64
It is also possible to manually toggle each of the valves in the DIAGNOSTIC mode. Refer to
Section 9.1.3 for information on using the DIAG mode. Also refer to Figure 8-4, Figure 8-5 for a
pneumatic diagram of the system. Check for fitting leaks and crimped tubing.
Section 9.1.3 for information on using the DIAG mode. Also refer to Figure 8-4, Figure 8-5 for a
pneumatic diagram of the system. Check for fitting leaks and crimped tubing.
9.3.10. Pneumatic System
The pneumatic system is diagrammed in Figure 8-4, Figure 8-5, depending on which options the
instrument was ordered with.
instrument was ordered with.
9.3.10.1. Leak Check
CAUTION
When doing a leak check do not pressurize
the M200AH to greater than 15psi.
Damage to internal components will
occur at higher pressures.
The root cause of many performance problems is a leak. Refer to Section 8.6 for the leak check
procedure.
procedure.
9.3.10.2. Pump
The external sample pump is capable of maintaining the cell pressure at 5"-Hg-A. If higher
pressures are noted, the pump may need servicing. Common pump problems and causes are:
pressures are noted, the pump may need servicing. Common pump problems and causes are:
1. Failure of ozone scrubber, thus allowing ozone into the pump. Ozone is very corrosive and
causes failure of the diaphragm. Replace catalytic ozone scrubber in the NO
2
-to-NO
converter, replace charcoal scrubber on pump pack, and rebuild the pump.
2. Sometimes the felt pads in the charcoal ozone scrubber plug up, thus restricting flow, and
decreasing effective vacuum even if pump is good.
3. Failed pump. The pump has a finite lifetime. There is a re-build kit, see the spare parts list.