数据表 (AT32UC3L-EK)目录1 Introduction12 Kit overview22.1 Features32.2 Kit content42.3 Power up and getting started42.4 References42.4.1 The AVR UC3 L0 series datasheet42.4.2 The AT32UC3L-EK schematics42.4.3 The AVR32777: AT32UC3L-EK Getting Started document42.4.4 The 32-bit AVR UC3 L series schematic checklist52.4.5 The Atmel AVR Software Framework52.4.6 The Atmel AVR UC3 UART boot loader52.4.7 The Atmel QTouch Library52.4.8 Atmel AVR QTouch Studio52.4.9 Debuggers53 Hardware description63.1 Power supply63.1.1 Overview63.1.2 Schematics73.1.3 UC3L-specific information73.1.4 Configurations and test points83.1.5 Power consumption measurement93.2 User interface103.2.1 Overview103.2.2 Schematics113.2.3 UC3L-specific information123.2.4 Configuration and test points133.3 Programming and debugging interface133.3.1 Overview143.3.2 Schematics143.3.3 UC3L-specific information143.3.4 Configuration and test points153.4 External memory163.4.1 Overview163.4.2 Schematics173.4.3 UC3L-specific information173.4.4 Configuration and test points173.5 RTC183.5.1 Overview183.5.2 Schematics193.5.3 UC3L-specific information193.5.4 Configuration and test points193.6 Expansion interface203.6.1 Overview203.6.2 Schematics213.6.3 UC3L-specific information213.6.4 Configuration and test points233.7 USB interface233.7.1 Overview243.7.2 Schematics263.7.3 UC3L-specific information263.7.4 Configuration and test points263.8 Atmel AT32UC3L064273.8.1 Overview273.8.2 Schematics283.8.3 AT32UC3L064 pinout283.8.4 Configuration and test points304 Schematics and assembly top/bottom views315 Errata325.1 While using the touch sensors, if the bottom side is touched, the touch events are wrong325.2 The pin-through holes near the touch sensors may cause spurious touch events325.3 The kit will not operate if power-hungry add-ons are connected to the expansion headers325.4 The RZ600 radio boards as well as RZ600 USB dongle are not more included in the kit326 Evaluation board/kit – important notice337 Table of contents34文件大小： 1.1 MB页数： 36Language: English打开用户手册
数据表 (AT32UC3L-EK)目录1 Introduction12 Powering up the Board23 Touch Demonstration firmware communicating with Atmel AVR QTouch Studio43.1 Description of the Demonstration53.2 Demonstration setup53.2.1 Connect the AT32UC3L-EK USB to a USB port of a PC53.2.2 Launch Atmel AVR QTouch Studio 4.2 (or higher) on the PC64 References and Further Information74.1 Detailed Hardware References (and associated Errata)74.2 Application Notes Running on this Kit74.3 Atmel AVR Software Framework74.4 Tools84.4.1 IDE and Compilers: Design Software84.4.2 Programming and On-Chip Debugging Tools: Debug Tools84.5 Support8文件大小： 2.6 MB页数： 9Language: English打开用户手册
