Bowflex 1000 Benutzerhandbuch

Assembly Manual

    •  TreadClimber

®

 Base and Treadle assembly from Step 7

    •  Console/Handlebar Assembly

    •  (6) 5/16” x 1” Button Head Screws
    •  (6) 5/16” Flat Washers SAE

    •  3/16” Hex Key (included)

Note: This step requires two people.

7-1   Lift and position the console/handlebar assembly above 

the upright supports (See Figure 7-1).

7-2   Put the console/handlebar assembly cable through the top 

of the right upright support (See Figure 7-2). Make sure 
that the cable extends throught the bottom of the right 
upright.

7-3   Put both sides of the console/handle bar brackets into the 

tops of the upright supports at the same time. Do not crimp 
the cable.

7-4   Tighten the hardware with the 3/16” hex key (See Figure 

7-3).

7-5   Connect the cable from the upright support to the cable on 

the right side of the base upright bracket (See Figure 7-4). 
Repeat this step on the other side.

7-6   One person will hold the Console/Handlebar assembly 

while the second person removes the 5/16” x 1” button 
head screw at the base of the support from each side.

7-7   Lower the upright on to the upright bracket base. Do not crimp 

the cables. Drop the upright until flush with the base frame. 

7-8   Attach the upright with (6) 5/16” x 1” button head screws 

and (6) 5/16” flat washers SAE.

Note:  Tighten the front (2) screws first (1 per upright) and then 

the (4) side screws, two per outer side of upright (See 
Figure 7-5).