American Innovative, 7000 Benutzerhandbuch

FLEXmount

™

  Set-up Options        Page 5

Step 1

NOTE: The rounded part 
of the nut should be facing 
downward.

Drill a hole 3/8” into desk or mounting surface bout 1 
1/2”-2” in from the edge of the surface edge.

Step 2

Remove the backing on 
the Neoprene foam pad 
and affix to the bottom of 
the mount cup.  (ONLY if 
you will not be using the 
baseplate set-up in the 
next step)

Step 3
Line up the mount cup over the hole and drop the 
2.5” threaded bolt into the mount cup, through the 
optional base plate and through the desk.

Without 

Baseplate

With 

Baseplate

Step 4

Under the desk, slide 
the rectangular spacer 
onto the 3/8-16 x 2 1/2” 
Hex Head Bolt.  Attach 
the nut to the bolt and 
tighten until the mount is 
secured to the desk.

Step 1

Align the mount cup over the short end of the large “L” 
bracket so you can screw the two components together 
using the 3/8-16 x 7/8” Button Head Socket Cap screw and 
tighten using the 7/32” allen wrench.  The mount is secure 
when the 3/8” screw no longer turns.

If you are using the Reverse Mount configuration, the 
3/8-16 x 1 1/4” Flat Socket Cap Screw should be used.

Secure the large “L” bracket to a stud in the wall using wood 
screws.
Reverse Wall Mount:  Follow Step 1 above; be sure the short 
side of the “L” bracket is on top.

Mounting

Hardware

Mounting

Hardware

Step 2

Drop the nylon stop nut into the impres-
sion inside the mount cup.  

The rounded top of the nylon stop nut 
should be facing upward.

Step 3

Reverse