Wyse Technology Release 2.0.2 Benutzerhandbuch
2
Converting Wyse S Class to
ThinOS
ThinOS
This chapter provides the step-by-step instructions you need to convert Wyse S class
cloud clients to ThinOS using Wyse Simple Imager.
cloud clients to ThinOS using Wyse Simple Imager.
Procedures
Step 1: Install Wyse Simple Imager 2.0.2
Install Wyse Simple Imager 2.0.2 (contained on the Conversion Software Assembly
CD-ROM) using the instructions in "Installing Wyse Simple Imager 2.0.2."
CD-ROM) using the instructions in "Installing Wyse Simple Imager 2.0.2."
Step 2: Copy the Correct 1S10 Folder and 1S10.i2d File (on the CD-ROM) to Correct
Locations
1. Determine the flash size of your cloud client (location of the flash size is as follows):
•
S30: Start > Settings > Control Panel > System > System Info tab
•
S50: Start > Control Panel > System > System Information > Identity tab
•
S90: Start > Control Panel > System > Client Information > General tab
The displayed flash size of your cloud client determines which Conversion Image
folder you must use on the Conversion Software Assembly CD-ROM (for example, if
your flash size is displayed as 128 MB, you must use the 128MB Conversion Image
folder on the Conversion Software Assembly CD-ROM). NOTE: See your cloud client
documentation for help on viewing the flash size.
folder you must use on the Conversion Software Assembly CD-ROM (for example, if
your flash size is displayed as 128 MB, you must use the 128MB Conversion Image
folder on the Conversion Software Assembly CD-ROM). NOTE: See your cloud client
documentation for help on viewing the flash size.
2. Open the correct Conversion Image folder you need on the Conversion Software
Assembly CD-ROM for your cloud client (either 64MB Conversion Image, 128MB
Conversion Image, or 512MB Conversion Image).
Conversion Image, or 512MB Conversion Image).
3. Open the WSI folder contained in the Conversion Image folder you need (for example,
if your flash size is 128 MB, open the 128MB Conversion Image folder, and then open
the WSI SX0 128MB ThinOS Conversion folder).
the WSI SX0 128MB ThinOS Conversion folder).
4. Copy the 1S10 folder (contained in the WSI folder) to
C:\Inetpub\ftproot\Rapport\Tools\sa (this is a folder created by WSI during installation
when using the default installation settings; see "Step 3: Install Wyse Simple Imager").
Note that this 1S10 folder will overwrite the existing 1S10 folder created during the
installation.
when using the default installation settings; see "Step 3: Install Wyse Simple Imager").
Note that this 1S10 folder will overwrite the existing 1S10 folder created during the
installation.
5. Copy the 1S10.i2d file (contained in the WSI folder) to any folder on the machine to
which you installed WSI (be sure the folder is accessible by WSI).