Panasonic CZ-RWST1U Bedienungsanleitung

4

Receives the signal sent from the remote 
controller.

When an error occurs, one of the lamps fl ashes. When a 
display lamp is blinking, refer to “14. BEFORE 
REQUESTING SERVICE”.

This lamp is lit when the unit is operating.

This lamp is lit when the timer is set.

•  When the heater is working, the lamp 

lights at the following times. When the 
thermostat has operated during defrosting 
at the time of the startup.

•  The lamp fl ashes when an error occurs.

This lamp is for notifying you when the fi lter 
needs to be cleaned.

Use in the Normal position. It does not 

operate in the Stop All position.

Remote control, main / remote control, 
secondary, switch
In normal use this should be on remote 
control, main. It is also possible to use both 

in conjunction with a wired remote controller 
(sold separately). (Consult with the dealer 
where the product was purchased about 
making the settings.)

Test/On switch
This is used during service. It is not for 
normal use.

Test Run/On switch
This is used during service. It is not for 
normal use.

Differentiate between incoming and outgoing 
signals.

•  If a heat pump model is being used, it will beep 

twice and the operating lamp will light up on the 
display; if the timer and standby lamps blink 
alternately, a confl ict between the heating and 
cooling exists, so the unit cannot operate in the 
desired mode. (On models that do not have Auto 
function, even if Auto is selected, it works in the 
same way.)

•  When the local operation is disabled by such as 

the centralized control, and if the Start, Stop, Mode 
or Temperature setting buttons are pressed, the 
unit will beep fi ve times and the change will not be 
made.

RECEIVER

Instruction_eng.indd   4

Instruction_eng.indd   4

2012/01/27   16:25:32

2012/01/27   16:25:32