Philips SRP5004/86 Benutzerhandbuch

Getting started

2.1 Inserting the batteries
•

Insert 2 AAA type batteries,

noting the + and -

configuration in the battery

compartment.

Note

When replacing the batteries, all user settings will be

retained in the remote control memory for 5 minutes.

2.2 Setting up the universal remote control

The example below instructs you how to set up your

universal remote controls for your TV.

You can repeat the same steps for other devices (STB, DVD

player/recorder and VCR) which you want to operate, using

the SRP5004.
The remote control can be set up to operate any 4 of the

following devices:

Device name

Description

Traditional TV, flat screen TV and

projection TV, TV part of TV / VCR, TV /

VCR / DVD and TV / DVD combos

STB

Cable box, satellite receiver, Digital

Video Broadcasting Terrestrial device

(DVB-T), Internet Protocol TV

(IPTV), Free To Air TV, High Definition

Television decoder (HDTV)

DVD

DVD player / recorder (DVDR), DVD /

Hard Disk Drive combination (DVDR-

HDD), Blu-Ray player, High Definition

DVD player (HD-DVD), DVD part of

TV / DVD, TV / VCR / DVD and VCR /

DVD combos

VCR

Video cassette player / recorder, VCR

part of TV / VCR, TV / VCR / DVD and

VCR / DVD combos

Example: setting up the universal remote control to

operate your TV:

Switch ON the TV manually or use the original remote

control for this. Tune to channel 1.

Press and hold the

device selection button

for 5 seconds until the red

Setup LED lights up.

• The remote control is

now in setup mode.

Look up the 4-digit

code for your brand in the

brand list at the back of this

user manual.

A four-digit code is shown

for each brand.

Use the digit buttons to

enter the code for your

brand.

• If the red Setup LED

turns off, an invalid code

was entered. In this case,

try again.

Aim the remote control at

the TV. Press and hold the

button. Release it

immediately as soon the TV

switches off.

•

This step normally
takes between 5 and 60 seconds. In extreme
circumstances this step can take up to 15 minutes.

Switch ON the TV.

Try out the buttons you

need for operating it. Try, for

example, if the - CH + and

digit buttons function

properly.

• If a button does not work as expected, press and hold

that button. Release it immediately as soon as it works.

For more information, see chapter 2.2.2.

Press the device

selection button twice to

finish setup.

•

When no button is

pressed for 5 minutes

or more, the remote

control will exit setup mode, automatically saving all

your settings.

Getting

star

ted

English

5 sec.

5 - 60 sec.

5-60 SEC.

2 x