Panasonic AW-CB400L Benutzerhandbuch

7 (E)

K

When connecting the pan/tilt control panel for operation,
connect this connector to the CAMERA CONTROL IN
FROM ROP connector on the pan/tilt control panel using
the control panel’s connecting cable. The cameras are
then controlled through the pan/tilt control panel.

L

Connect this to the TALLY/INCOM connector on the
video switcher or other units.
When the TALLY connector is set to the GND level, the
(

1

) TALLY lamp lights. Do not apply a voltage in excess

of 5V to this connector.

Use the accessory tally/INCOM connector (D-SUB 15-pin)
to connect the tally/INCOM signals to the system.
Connect a 4-wire INCOM system to the INCOM
connector.
When the ROP has been connected to the pan/tilt control
panel, the tally/INCOM functions of the ROP and the
pan/tilt control panel will be executed if the tally/INCOM
signals are connected to the ROP or the pan/tilt control
panel.

M

Connect these to the convertible cameras.
Use the connecting cables (optional accessory) 
AW-CA50T8 or AW-CA50T9 + RS-422/RS-232C
converter to connect these connectors to the I/F
REMOTE connectors on the convertible cameras.

N

Connect the AW-PS505 AC adaptor (optional accessory)
to this socket.
When the ROP is connected to the pan/tilt control panel
using the pan/tilt control panel connecting cable, power
will be supplied to the ROP from the pan/tilt control panel.

O

Connect this terminal to ground.

K

L

M

N

O

$

Pin No.

Signal Name

1

TALLY1

9

TALLY2

2

TALLY3

10

TALLY4

3

TALLY5

11

TALLY GND

4

– – –

12

– – –

5

– – –

13

– – –

6

MIC +

14

MIC –

7

INCOM GND

15

SP –

8

SP +

87654321

?>=<;:9