Roland TU-500 Benutzerhandbuch
9
5. Adjusting the Sensor's Position
Turn on the power. Two LEDs
(green and red) light up.
(green and red) light up.
1
Loosen the screw as shown in the
figure, and adjust the angle of the
sensor so that it is aligned with
the mirror.
figure, and adjust the angle of the
sensor so that it is aligned with
the mirror.
2
Tighten the adjustment screw
securely at the angle where the
red LED has gone dark.
securely at the angle where the
red LED has gone dark.
3
Red LED
Green LED
Screw
LED goes dark
AUTO
Material is taken up automatically
when material has been fed into the
sensor's detection area.
when material has been fed into the
sensor's detection area.
BACKWARD
FORWARD
Material take-up is in
the direction shown at
right.
the direction shown at
right.
Material take-up is in
the direction shown at
right.
the direction shown at
right.
Sensor detection area
The TU performs material take-up when
material is fed into this area.
material is fed into this area.
Sensor
Mirror
Stand
CJ/FJ
Rear
Front
Power switch
OFF
No material take-up occurs, even when
material has been fed into the sensor's
detection area.
material has been fed into the sensor's
detection area.
MANUAL
The material is taken up manually.
4. Operation Panel