Universal Electronics 4-DEVICE Universal Remote Control Benutzerhandbuch

PROBLEM:

Mode key does not blink when you press a key.

SOLUTION: Replace the batteries with two (2) new AA 

alkaline batteries (see page 7).

PROBLEM:

Mode key blinks when you press a key, but home
entertainment device does not respond.

SOLUTION: Make sure you are aiming the remote control at

your home entertainment device and that you 
are within 15 feet of the device you are trying 
to control.

PROBLEM:

The remote control does not control home 
entertainment devices or commands are not 
performing properly.

SOLUTION: Try all listed codes for the device brand being set

up. Make sure all devices can be operated with
an infrared remote control.

PROBLEM:

TV/VCR combo does not respond properly.

SOLUTION: Use the VCR codes for your brand. Some combo 

units may require both a TV code and a VCR
code for full operation (see page 9).

PROBLEM:

No volume on a second TV.

SOLUTION: Follow instructions in Changing Volume Lock

(see page 28).

PROBLEM:

CH+ , CH – , and LAST do not work for your 
RCA TV.

SOLUTION: Due to RCA design (1983-1987), only the original

remote control will operate these functions.

PROBLEM:

Changing channels does not work properly.

SOLUTION: If original remote control required pressing

ENTER to change channels, press ENTER on the 
remote control after entering a channel number.

PROBLEM:

Tried “Search Method” and still could not find a
working code.

SOLUTION: Try the “Search Method” again after clearing out

the device key as follows: Press and hold SETUP
until mode key blinks twice, then release. Next
enter 9 - 9 - 2. Then press and release the mode
key to be cleared twice.

PROBLEM:

Remote control does not turn on Sony or Sharp
TV/VCR Combo.

SOLUTION: For power on, these products require program-

ming TV codes on the remote control. For Sony,
use TV code 0000 and VCR code 0032. For Sharp,
use TV code 0093 and VCR code 0048.

Atlas Manual  4/8/02  9:37 AM  Page 30