HP (Hewlett-Packard) I2000 Benutzerhandbuch

Installing HP-UX 11i Version 1.5

To cold install the operating system, which overwrites everything on the
target disk:

Step 1. Make sure any external devices connected to the target system are

turned ON and operational.

Step 2. Insert the HP-UX 11i Version 1.5 DVD into the drive.

Step 3. Turn the system ON, reboot, or cycle power. The system should boot

automatically from the DVD; if it does, go directly to step 4.

IMPORTANT: If the system does not boot automatically, you will be
taken to the boot menu, which is a timed menu -- press any key to stop
the timer. Then, you can run

install

 manually from the EFI shell, as

follows:

1. Select

EFI Shell (Built In)

from the boot menu.

2. Display the list of devices by typing:

(The

-b

 command line option scrolls the screen one page at a time in

the event that the device list is longer than one page.)

3. Look at the list of devices (displayed as

fs0

,

fs1

, etc.) and identify the

DVD-ROM device. An example of a DVD-ROM device entry from the

map

 command:

fs0 : Acpi (PNP0A03),0)/Pci(3|1)/Ata(Secondary,Master)

/CDROM(Entry1)

4. The

edd30 [on | off ]

 command toggles the BIOS option to

display device path according to the EDD 3.0 specification. If the
BIOS option is

off

, the root disk must be located at target 0. If the

root disk is not located at target 0, type :

to enable EDD 3.0.

5. Then enter the command

device_name:\install

. For example, if

the DVD-ROM device is

fs0

, you would enter