Panasonic J-HD1400P Benutzerhandbuch

51

*1 Displayed menus may vary depending on the settings in

menu No. 25 SYSTEM FREQ. For details, refer to
“Menus which are displayed” (page 32).

“_____” indicates the factory setting.

For setting the reference level of the analog audio 
input (CH1).
0000

For setting the reference level of the analog audio 
input (CH2).
0000

For setting the reference level of the analog audio 
output (CH1).
0000

For setting the reference level of the analog audio 
output (CH2).
0000

For setting the reference level of the analog audio 
output (Lch).
0000

For setting the reference level of the analog audio 
output (Rch).
0000

For selecting whether or not to enable  the  
headphone volume control knob for the volume of an 
audio monitor output.
0000

The signals are output at a fixed level.

The signal output is coupled with the headphones 
volume control.

This selects the input signal to be recorded on the 
audio CH3/4 track.
0000

Audio input CH1/2 signal.

Mute

<Notes>
z This item is effective for analog input only.
z When selecting analog input, the same data as 

CH1 to CH4 is recorded in CH5 to CH8.

For setting the input signal to be recorded on the CUE 
track.
0001

Audio input CH1 signal

Audio input CH2 signal

Audio input CH3 signal

Audio input CH4 signal

Audio input CH5 signal

Audio input CH6 signal

Audio input CH7 signal

Audio input CH8signal

Audio input CH1 + CH2 mixed signal

Audio input CH3 + CH4 mixed signal

Audio input CH5 + CH6 mixed signal

Audio input CH7 + CH8 mixed signal

Audio input CH1 through CH8 mixed signal

<Notes>
z For analog input, this is interlocked to the settings 

in menu No. 724 REC CH3/4.

z Audio signal is not recorded in the CUE track when 

inputting 1394. (Mute)

For setting the processing for the audio edit points (IN 
point, OUT point) and followon recording point during 
playback.
0000

The processing follows the status established 
during recording.

Cut processing is forcibly performed.

Fade processing is forcibly performed.

For setting whether to superimpose audio data onto 
the HD SDI output and SD SDI output.
0000

The audio data is not superimposed.

The audio data is superimposed.

For selecting the monitor output.
0000

The signal selected by the MONITOR SELECT 
button is output.

The PCM audio signal is output when the speed 
range is less than 

j1.0k to +1.0k; the CUE 

AUDIO signal is output at all other speeds.

The PCM audio signal is output in the 

j32k to 

i32k speed range.

<Note>
When the L/R selection is CUE with the MONITOR 
SEL button on the front panel of this unit, CUE 
AUDIO is output at all speeds, regardless of the 
above menu.
During playback of DV/DVCAM tapes, the operation 
uses a “MANU” setting regardless of the setting in 
this item.