Panasonic PV-V4525S Benutzerhandbuch
Connections / Initial Setup (Ready to Play)
Connecting (Select a method)
Connect cable from
Antenna/Cable to VCR’s IN
FROM ANT. jack.
Antenna/Cable to VCR’s IN
FROM ANT. jack.
Connect VCR’s OUT TO TV
jack to TV’s ANT. IN jack
with included RF Cable.
jack to TV’s ANT. IN jack
with included RF Cable.
For ANT./Cable
➛
➛
➛
➛
➛ VCR ➛
➛
➛
➛
➛ TV
For DSS/Cable Box
➛
➛
➛
➛
➛ VCR ➛
➛
➛
➛
➛ TV
Connect your cable box’s OUT
jack to the VCR’s IN FROM
ANT. jack with an RF cable.
jack to the VCR’s IN FROM
ANT. jack with an RF cable.
Connect VCR’s OUT TO TV
jack to TV’s ANT. IN jack
with included RF Cable.
jack to TV’s ANT. IN jack
with included RF Cable.
1
2
1
2
Make all cable or antenna connections before plugging into an AC outlet.
Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.
1
Turn TV on and tune to channel 3.
2
Plug VCR Power Cord into AC wall outlet.
VCR comes on and auto channel and clock
set starts.
VCR comes on and auto channel and clock
set starts.
• If screen below does not appear...
check all connections.
Try tuning TV to channel 4.
Try tuning TV to channel 4.
• To change VCR’s output channel,
see “VCR’s Output Channel” (p. 12)
in Advanced Operations book.
in Advanced Operations book.
If you use a cable box, turn it on and set it to
the Public Broadcasting Station (PBS) channel
in your time zone. If you use a DSS receiver, it
must be turned off.
the Public Broadcasting Station (PBS) channel
in your time zone. If you use a DSS receiver, it
must be turned off.
Initial Setup (Ready to Play)
3
Settings are made automatically.
When complete, this screen appears.
When complete, this screen appears.
If “AUTO CLOCK SET IS INCOMPLETE”
appears, manually set clock (below).
appears, manually set clock (below).
Manual Clock Set
If Auto Clock Set was incomplete.
1
Press ACTION* on remote to display
CLOCK menu.
CLOCK menu.
2
Press
to select the month and to set.
In the same manner, select and set the
date, year, time, and DST (Daylight Saving
Time).
date, year, time, and DST (Daylight Saving
Time).
3
Press ACTION to start clock and exit.
- 4 -
Plug VCR Power plug into an AC wall outlet.
AUTO CLOCK SET
IS I NCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACT I ON KEY
PRESSING ACT I ON KEY
• Function buttons are void during Initial Setup.
• To eject a tape during Auto Set, press EJECT
• To eject a tape during Auto Set, press EJECT
on remote or STOP twice on VCR.
Then make settings manually.
(See Advanced Operations book, p. 12.)
Then make settings manually.
(See Advanced Operations book, p. 12.)
• If Auto Clock Set takes more than 30 minutes,
press STOP and perform settings manually.
(See Advanced Operations book, p. 12.)
(See Advanced Operations book, p. 12.)
Notes
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
CH AUTO SET PROCEEDING
CANCEL : STOP
1
2
2
1
Over tightening “Nut type” RF coaxial cables
may damage jacks. Finger tighten only.
may damage jacks. Finger tighten only.