Panasonic AJ-D650 Benutzerhandbuch

604 V-MUTE

0000

N-MUTE

This selects whether the video output signal is to be muted in

SEL

0001

LOW-RF

the event of a low RF or disengaged servo lock during

playback.
0: No muting (picture freezes).

1: Muting (picture turns grey).

605

CC (F1)

0000

BLANK

0001

BLANK

This selects ON or OFF for the closed capture signal in the

THRU

first field.
0: Forced blanking performed.

1: Blanking not performed.

F I E L D

606

CC (F2)

BLANK

0000
0001

BLANK

This selects ON or OFF for the closed capture signal in the

THRU

second field.
0: Forced blanking performed.

1: Blanking not performed.

608 FREEZE

SEL

0000
0001

This 

selects the freeze mode for still pictures.

FRAME

0: Field freeze

1: Frame freeze

<Note>
When frame freeze is selected, the frame freeze mode is
established even during slow motion.

609

IN FRM
DET

0000

FORCED

This selects the conditions under which frame detection is to

0001

AUTO

be performed when signals are input.
0:

Frame detection is performed at all times.

1: Frame detection is prohibited only when non-standard

signals are input.

6 1 1   E D H

0000
0001

OFF

This selects whether to superimpose EDH onto the serial

ON

output signals.

0: EDH is not superimposed.

1: EDH is superimposed.
• This item setting is valid when the optional serial interface

board has been installed.

612 WIDE

SELECT

0000
0001
0002

AUTO

This selects the operation to be conducted in response to the

WIDE

WIDE information.

NORMAL

0: During recording, if the Y/C input signals contain WIDE

information, the WIDE information is recorded on the tape.

During playback, if WIDE information is on the tape, it is

added to the Y/C output signals.

1:

During recording, the WIDE information is recorded on the

tape regardless of whether the Y/C input signals contain
the WIDE information.

During playback, the WIDE information is added to the Y/C

output signals regardless of whether the WIDE information
is on the tape.

Forced WIDE ON

2:

During recording, the WIDE information is not recorded on

the tape regardless of whether the Y/C input signals
contain the WIDE information.

During playback, the WIDE information is not added to the

Y/C output signals regardless of whether the WIDE
information is on the tape.   Forced WIDE OFF

<Note>
This item is effective during recording at the start of the
recording and during playback at all times. Therefore, when its
setting has been changed during recording, the MENU
contents will be changed but no change will occur in the actual
operation.

The underline on the setting item denotes the initial setting.

– 3 5 –