Panasonic AJ-HD130DCP Benutzerhandbuch
11
Rear panel
Parts and Their Functions
>
Fan motor
This is for cooling the VTR.
?
Grip
Grips are provided on the side. These grips
notwithstanding, the VTR should be installed on a
level surface when it is to be operated.
notwithstanding, the VTR should be installed on a
level surface when it is to be operated.
=
REMOTE CONTROL connector
An external remote controller (AJ-A95, optional
accessory) can be connected here to enable the
VTR to be operated by remote control.
<Notes>
accessory) can be connected here to enable the
VTR to be operated by remote control.
<Notes>
O
Set the LOCAL/MENU/REMOTE switch to the
REMOTE position.
REMOTE position.
O
This connector complies with the RS-422A
interface standard but the functions related to
editing do not work.
interface standard but the functions related to
editing do not work.
6
VIDEO OUT (1, 2) connectors
These are the down-conversion output connectors
for the analog composite video signals.
Video signals with embedded superimposed text
can be output from the VIDEO OUT2 connector.
Superimposed text embedding can be selected
using setup menu item No.005.
for the analog composite video signals.
Video signals with embedded superimposed text
can be output from the VIDEO OUT2 connector.
Superimposed text embedding can be selected
using setup menu item No.005.
7
TC IN connector
This is used for recording the external time code
onto the tape.
onto the tape.
8
TC OUT connector
During playback, the playback time code is output
from this connector; during recording, the time code
generated by the internal time code generator is
output.
from this connector; during recording, the time code
generated by the internal time code generator is
output.
9
HD/SD REF VIDEO IN connectors and 75
Ω
termination switch
These are the input connectors for the HD/SD
reference video signals. For termination, set the
switch to ON.
<Notes>
reference video signals. For termination, set the
switch to ON.
<Notes>
O
Input a tri-level sync signal with both positive and
negative polarities when using these connectors
for the HD reference. Input a signal that
matches the input signals or tape format.
negative polarities when using these connectors
for the HD reference. Input a signal that
matches the input signals or tape format.
O
Input a composite video signal complying with
RS-170A or a black burst signal when using
these connectors for the SD reference.
RS-170A or a black burst signal when using
these connectors for the SD reference.
:
AUDIO IN connectors (CH1, CH2, CH3, CH4)
These are the input connectors for the analog audio
signals.
signals.
;
AUDIO OUT/MONITOR connectors (CH1, CH2,
CH3, CH4)
CH3, CH4)
These are the output connectors for the analog
audio signals.
The CH3 and CH4 connectors are also used as the
audio monitor output connectors (left channel, right
channel). (See page 7)
audio signals.
The CH3 and CH4 connectors are also used as the
audio monitor output connectors (left channel, right
channel). (See page 7)
<
HD SDI IN, OUT connectors
These are the input and output connectors of the
digital component audio and video signals
complying with the SMPTE 292M, 296M or 299M
standard.
These are the input and output connectors of the
digital component audio and video signals
complying with the SMPTE 292M, 296M or 299M
standard.
Pin No.
Signal
1
Frame Ground
2
Transmit A
3
Receive B
4
Receive Common
5
————
6
Transmit Common
7
Transmit B
8
Receive A
9
Frame Ground
1
6
9
5