Panasonic AJ-HD1400P Benutzerhandbuch

53

*1 Displayed menus may vary depending on the settings in

menu No. 25 SYSTEM FREQ. For details, refer to
“Menus which are displayed” (page 32).

“_____” indicates the factory setting.

For setting the transfer speed of the IEEE1394 digital 
interface output.
0000

100 Mbps

200 Mbps

400 Mbps

<Note>
When S100 has been selected as this item’s setting, 
DVCPRO HD format signals cannot be input or 
output.

For setting the input channel.
0000

The input channel is fixed at the channel 
corresponding to the number specified.

The input channel is not fixed at the channel 
corresponding to the number specified. The input 
channel is initialized to 63 when the power is 
turned on.

For setting the output channel.
0000

The input channel is fixed at the channel 
corresponding to the number specified.

The output channel is not fixed at the channel 
corresponding to the number specified. The output 
channel is initialized to 63 when the power is 
turned on.

Menu item for expansion purposes.  Normally, use 
DFLT as the setting.
0000

For setting the audio channels to which the signals 
from the IEEE1394 digital interface are to be output in 
the DV format when a DVCPRO HD tape or 50M 
format tape is played back or when a DV tape in 4ch 
mode is played by the audio signals and menu No. 
891 DIF DV AUDIO is set to “LOCK48.”
0000

CH1 and CH2

CH3 and CH4

For setting forcible audio mode conversion when a DV 
tape is played back and the audio signals are output 
in the DV format.
0000

Normal setting (the signals simply pass through).

Forcible conversion to the LOCK mode (no 
frequency conversion)

Forcible conversion to 48kHz/2CH/LOCK.

For setting how to reply when signals requesting a 
confirmation of the format is sent from an external 
device connected by the IEEE1394 digital interface.
0000

DVDPRO50 is forcibly returned.

DVDPRO is forcibly returned.

DV is forcibly returned.

The reply is the same format as the signal format 
output from the IEEE1394 digital interface.

<Note>
When the unit is connected to a non-linear editing 
system using 50M, 25M, and DV signal format, the 
non-linear editing system may not operate properly. In 
this case, set the value to reply with the format signal 
supporting the connected signal format and start the 
system.

> DIF 

For selecting channels that are adjusted with the 
audio volume control on the front panel and displayed 
on the audio level meter.
0000

DVCPRO HD

DVCPRO50

DV

> DIF 

For setting the format of the signals to be output from 
the IEEE1394 digital interface when a 50M format 
tape is played back.
0000

DVCPRO50

DV

<Note>
When DV is selected as this item’s setting, the closed 
caption signals and time code (VITC) signals in the 
vertical blanking period are transmitted, but none of 
the other signals in the vertical blanking period are 
transmitted.

> DIF 

For setting the format of the signals to be output from 
the IEEE1394 digital interface when a 25M format 
tape is played back.
0000

DVCPRO

DV

For setting whether the superimposed display is to be 
output from the IEEE1394 digital interface when the 
format is converted (from HD to 50M, from HD to DV, 
from 50M to DV or from 25M to DV).
0000

The superimposed text is not displayed.

The superimposed text is displayed.

<Note>
Only TCR is displayed.