Toshiba D-VR17KB Benutzerhandbuch

24

EN

You can replace two channels.

U / D], 

U / D], then 

U / D], then 

U / D], then press [ENTER].

You cannot select a position number where 
“– – –” appears next to the number, because 
“Skip” is set to “ON” for that position number.

U / D], then 

• To move another channel, repeat steps 4 to 5.

Channel Tuning must be set before setting Auto 
Clock.

U / D], 

U / D], then 

U / D], then press [ENTER].

U / D], then 

The current time will be set automatically.

The Auto clock function is activated.
This unit will search for the time every time when 
the power is turned off. Leave the unit off for 
several minutes to give it time to set the clock.

• If you want to cancel “Auto Clock Setting,” select 

“OFF” using [

U / D], and then press [ENTER] at 

step 4.

• The default setting of “Auto Clock Setting” is “ON.”
• The clock may set itself automatically after you 

connect the antenna cable to the unit and plug in the 
mains cable. In this case, the current time will 
appear on the front panel display.

• To set the clock automatically, the channel assigned 

to “P04” must receive the PDC signal.

• The clock cannot be set automatically if you are not 

receiving a channel in your area that carries a time 
signal. In this case, set the clock manually.

• Once the auto clock setting is performed, the unit 

will correct the current time by receiving PDC 
broadcasts whenever the power is turned off.

• The unit will correct the current time automatically at 

8:00, if the unit is in standby mode.

• Between 23:00 and 1:00, the Auto Clock function 

will not operate even when the power is turned off.

E9GA0BD_EN.book  Page 24  Monday, March 26, 2007  10:14 AM