Toshiba D-VR17KB Benutzerhandbuch

Select the desired setting using
[

U / D], then press [ENTER].

• If you select “Component Progressive (P)”, proceed

to step 2 below.

• If you select “SCART (RGB)” or “Component

Interlace (I)”, your setting is activated.

• Refer to pages 19 and 20 for more details.

Using [

L / P] to select “Yes”. Press

[ENTER].

Final confirmation window will appear.

Using [

U / D] to select “Yes”. Press

[ENTER] within 15 seconds.

Your setting is activated.

Note

• If your TV is compatible with Progressive Scan

(625p/525p), you must use the Component Video
cable (commercially available) to connect this unit to
the TV.

• When changing the Video Out setting (“SCART

(RGB)”, “Component Interlace (I)” or “Component
Progressive (P)”), connect to a VIDEO jack or an
S-VIDEO jack on the TV. If the setting is changed,
for example, to “SCART (RGB)” while the
COMPONENT VIDEO OUT jacks are used to
connect to the TV, a distorted video signal may be
output.

DivX

In stop mode, press [SETUP]. Select
“General Setting” using [

U / D],

then press [ENTER].

Select “DivX” using [

U / D], then

press [ENTER].

Select the desired item using
[

U / D], then press [ENTER].

For DviX

VOD, refer to page 45 for details.

DivX Subtitle (Default: OFF)

Select the desired setting using
[

U / D], then press [ENTER].

When you finish with the setting,
press [SETUP] to exit.

Video Out

SCART (RGB)
Component Progressive (P)
Component Interlace (I)

Activating progressive scan:
Check your TV has progressive scan
and connect with component video cable.

NOTE:

If there is no picture or picture is
distorted after selecting “Yes”,
wait about 15 seconds for autorecovery.

Activate?

Yes

Confirm again to use progressive scan.
If Picture is good, select “Yes”.

Yes

General Setting

Display
Video

Clock
Channel
DivX
Reset All

Recording

Playback

DivX

VOD

DivX Subtitle

OFF
English
French
Spanish
German
Italian
Swedish

E9GA0BD_EN.book Page 70 Monday, March 26, 2007 10:14 AM