Toshiba EM1-31064JE Benutzerhandbuch

17-1

EM1-31064

17.  CLEANING THE PRINT HEAD

If the print head is dirty, printing will not be clear.  The print head should be cleaned with a print head
cleaner everyday before use, according to the following procedure:

1.

Open the label cover and remove the label cassette.  (See page 9-1)

2.

Clean the print head element with the print head cleaner.

3.

Clean the print head element with the print head cleaner.

NOTE: Be careful not to damage the print head when cleaning.
4.

If any label paste is found on the cutter, wipe off the paste with alcohol.

1.

Install an unloaded label cassette on the scale.

2.

Install the label cutter, aligning the cutter notches with the screw holes.

3.

Secure the cutter with the screw (FL-3x6) so the bottom of the cutter is 0.5~0.8 mm above
the peel-off plate.

Print Head

Print Head Cleaner

Element

Screw (FL-3x6)

Clearance
0.5~0.8 mm

Peel-off Plate

Label Cutter

Screw (FL-3x6)

Head Holder

Label Cutter

Since there is a cutter at the paper outlet, be careful not to injure your fingers when
cleaning the print head and cutter.

NOTE: If the cutter is scratching labels during printing, increase the clearance between the cutter

and peel-off plate.