Timex W-106 Benutzerhandbuch

1. To set alarm press MODE to select ALM mode.
2. Press LAP/RESET to select ALM1 or ALM2. Alarm 1 will apply to TM-1 and ALM2 will apply to

TM-2. (See Time-Date).

3. Press and hold LAP/RESET for 2 seconds to select SET mode. Minute digits blink.
4. Press ST/STOP* to set minutes.
5. Press MODE. Hour digits blink.
6. Press ST/STOP* to set hours.
7. Press LAP/RESET to confirm and exit.

Press ST/STOP: once, alarm on 

; twice, chime on 

; three times both on

; four times both off. Press any button to silence alarm or chime.

*Hold ST/STOP to speed up process.

To set:
1. Press MODE to select TMR mode. Last reading will be displayed.
2. Press LAP/RESET repeatedly to select 1,3,5,10,15,20,25,30,45 or 60 minutes.

To use:
1. Press ST/STOP once to start countdown.
2. Press ST/STOP at any time to stop counting and again to resume.
3. A beep will sound when timer reaches zero. Press any button to silence. Timer will automati-

cally return to set time.

4. Press LAP/RESET to clear.

1. Press MODE to select STW mode. Last reading will be displayed.
2. Press LAP/RESET to clear.
3. Press ST/STOP once to start stopwatch. Stopwatch will go back to zero after 59 minutes and

59.99 seconds.

4. Press ST/STOP at any time to stop counting. Press again to resume.
5. To clear, press ST/STOP to stop counting. Press LAP/REST to clear.

Use split function to keep track of individual lap times:
1. While stopwatch is running, press LAP/RESET. Split indicator will appear.
2. Press LAP/RESET again to return to accumulated time. Split indicator will disappear.
3. Press ST/STOP to stop counting. Press LAP/RESET to clear.

Note: You can switch to other modes while stopwatch is running.

will appear indicating

activity.

If your watch is water-resistant, meter marking or (

) is indicated.

Water-Resistance Depth

p.s.i.a.* Water Pressure Below Surface

*pounds per square inch absolute

Timex strongly recommends that a retailer or jeweler replace battery. If applicable, push
reset button when replacing battery. Battery type is indicated on caseback. Battery life esti-
mates are based on certain assumptions regarding usage; battery life may vary depending on
actual usage.

1. Watch is water-resistant only as long as lens, push buttons and case remain intact.
2. Watch is not a diver watch and should not be used for diving.
3. Rinse watch with fresh water after exposure to salt water.

Press INDIGLO® to activate night-light. Patented (U.S. pat 4,527,096 and 4,775,964) electrolumi-
nescent technology used in INDIGLO® night-light illuminates entire watch face at night and in
low light conditions. While the night-light is on pressing any button keeps it on for three seconds.

Press and hold INDIGLO for 4 seconds to activate NIGHT-MODE® Feature (U.S. pat. 4,912,688).
Moon icon 

will appear. Once activated, any button pushed will cause INDIGLO® night-light

to stay on for 3 seconds. NIGHT-MODE® Feature will stay activated for 8 hours or until deacti-
vated by pressing and holding INDIGLO again for 4 seconds.