Siemens C450 IP Benutzerhandbuch

Gigaset C450 IP / IM-Nord EN / A31008-M1713-R201-3-7643 / starting.fm / 01.03.2007

Ve

rs

ion 4,

 16

.09.

2005

The display is protected by a plastic film. 

Please remove the protective film! 

¤

Insert the batteries the right way round 

(see figure).

The polarity is indicated in the battery 

compartment.

The handset switches on automatically. 

You will hear a confirmation tone.

¤

Place the cover on the battery compart-

ment as shown in the diagram, then 

push it up until it clicks into position.

¤

Press down on the battery cover below 

its upper end and slide the cover down.

Connecting the charging cradle and 

mounting it on the wall (if required) is 

described at the end of this user guide.

¤

To charge the batteries, leave the hand-

set in the charging cradle. 

Battery charging is indicated in the top 

right of the display by a flashing battery 

icon 

e, V or U. During handset 

operation, the battery icon indicates the 

charge status of the batteries (page 1).
The correct charge status can only be dis-

played when the batteries are first fully 

charged and discharged through use. 

¤

To do this, leave the handset in the 

charging cradle without interruption 

until the battery icon stops flashing in 

the display (approx. 13 hours). 

¤

Once the batteries are fully charged, 

remove the handset from the charging 

cradle and do not put it back again until 

the batteries are fully discharged. 

Use only the rechargeable batteries recom-

mended by Siemens on page 30! This means 

that you must never use conventional (non-

rechargeable) or other battery types as this 

could result in significant health risks and 

damage to property. For example, the outer 

casing of the batteries could be destroyed or 

the batteries could explode. The phone could 

also malfunction or be damaged as a result of 

using batteries that are not of the recom-

mended type.

– Only place the handset in the charging cra-

dle that is intended for it.

– If the handset has switched itself off 

because the batteries are flat and if it is 

then placed in the charging cradle, it will 

switch itself on automatically.

After the first battery charge and discharge, 

you may replace your handset in the charging 

cradle after every call.