Motorola G24 Benutzerhandbuch
Call Control
3-16
AT Commands Reference Manual
December 31, 2007
atd>1;//Speed dial from phonebook
OK
OK
ath
NO CARRIER
OK
atd>1//Speed dial from phonebook
+CME ERROR://Invalid characters in dial string
atd>"Motorola Internal"
+CME ERROR://Invalid characters in dial string
For more examples, refer to
DL, Dial Last Number
The DL command places a data/voice call to the last number dialed. The call progress
information (success/failure) is reported in the same way as for the Dial command. (
information (success/failure) is reported in the same way as for the Dial command. (
).
The following table shows the DL parameters.
Note:
When ATDL is issued after a dialed number with comma digit:
Command
Detailed Description
ATDL[;]
Initial Response - Last Number retrieved:
ATDL: "DIAL DIGITS"
2nd response - Data/Fax call connected CONNECT
1st response - Voice call placement begins
OK
2nd response - Voice call connected OK
ATDL: "DIAL DIGITS"
2nd response - Data/Fax call connected CONNECT
1st response - Voice call placement begins
OK
2nd response - Voice call connected OK
Table 3-6: DL Parameters
<Parameter>
Description
semicolon (;)
If the semicolon (;) is given, a voice call is originated to the last dialed number.
If the semicolon (;) is not given, a Fax/Data call is originated.
If the semicolon (;) is not given, a Fax/Data call is originated.
Note:
The last dialed call type is irrelevant to the DL command.