Motorola G24 Benutzerhandbuch
Modem Configuration and Profile
3-282
AT Commands Reference Manual
December 31, 2007
Example
AT&F?
&F: 0
OK
Z, Reset to Default Configuration
This command drops the current call, and resets the values to default configuration.
The following table shows the Z parameters.
Example
ATZ0
OK
Sleep Mode Commands
When the G24 is connected using RS232 connection to external device, a sleep mechanism is
available. In order to improve the power consumption, the G24 supports a low-power
consumption mode, called "Sleep mode". The G24 has internal decision conditions for entering
and exiting sleep mode. As the terminal and the G24 operate in a combined system, and as the
communication between the G24 and the terminal must be reliable, there should be a mechanism
agreed upon by both the G24 and the terminal to co-ordinate their separate sleep mode entering
and exiting sequences. The G24 will not enter sleep mode unless the terminal enables the G24
available. In order to improve the power consumption, the G24 supports a low-power
consumption mode, called "Sleep mode". The G24 has internal decision conditions for entering
and exiting sleep mode. As the terminal and the G24 operate in a combined system, and as the
communication between the G24 and the terminal must be reliable, there should be a mechanism
agreed upon by both the G24 and the terminal to co-ordinate their separate sleep mode entering
and exiting sequences. The G24 will not enter sleep mode unless the terminal enables the G24
Command Type
Syntax
Response/Action
Remarks
Set
ATZ<value>
OK
or:
+CMS ERROR: <err>
Read
The Read command for Z is not
defined, and therefore is not supported
by the G24. The G24 returns an error.
defined, and therefore is not supported
by the G24. The G24 returns an error.
Test
The Test command for Z is not
defined, and therefore is not
supported by the G24. The G24
returns an error
defined, and therefore is not
supported by the G24. The G24
returns an error
.
Table 3-188: Z Parameters
<Parameter>
Description
<value>
0
Set to user profile 0
1
Set to user profile 1
The default value is 0.