Motorola G24 Benutzerhandbuch
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-329
Example
AT+CGQMIN=?
+CGQMIN: ("IP"),(0-3),(0-4),(0-5),(0-9),(0-18,31)
OK
AT+CGQMIN?
+CGQMIN: 1,2,4,3,9,10
+CGQMIN: 2,2,4,3,9,10
+CGQMIN: 3,2,4,3,9,10
OK
+CGQREQ, Quality of Service Profile (Requested)
This command enables the terminal to specify a Quality of Service Profile that is used when the
ME sends an Activate PDP Context Request message to the network.
ME sends an Activate PDP Context Request message to the network.
Command
Type
Syntax
Response/Action
Remarks
Set
AT+CGQREQ=[<cid>
[,<precedence>
[,<delay>
[,<reliability.> [,<peak>
[,<mean>]]]]]]
[,<delay>
[,<reliability.> [,<peak>
[,<mean>]]]]]]
OK
or:
+CME ERROR: <err>
The Set command specifies a profile
for the context identified by the (local)
context identification parameter,
<cid>. As this is the same parameter
that is used in the +CGDCONT
command, the +CGQREQ command
is effectively an extension of the
+CGDCONT command. The QoS
profile consists of a number of
parameters, each of which may be set
to a separate value.
A special form of the Set command,
+CGQREQ= <cid>, causes the
requested profile for context number
<cid> to become undefined.
for the context identified by the (local)
context identification parameter,
<cid>. As this is the same parameter
that is used in the +CGDCONT
command, the +CGQREQ command
is effectively an extension of the
+CGDCONT command. The QoS
profile consists of a number of
parameters, each of which may be set
to a separate value.
A special form of the Set command,
+CGQREQ= <cid>, causes the
requested profile for context number
<cid> to become undefined.
Read
AT+CGQREQ?
+CGQREQ: <cid>,
<precedence>, <delay>,
<reliability>, <peak>, <mean>
<reliability>, <peak>, <mean>
OK
or:
+CME ERROR: <err>
The Read command returns the
current settings for each defined
context.
current settings for each defined
context.
Test
AT+CGQREQ=?
+CGQREQ: <PDP_type>,
(list of supported
<precedence>s), (list of
supported <delay>s), (list of
supported <reliability>s), (list
of supported <peak>s), (list of
supported <mean>s)
<precedence>s), (list of
supported <delay>s), (list of
supported <reliability>s), (list
of supported <peak>s), (list of
supported <mean>s)
OK
or:
+CME ERROR: <err>
The Test command returns values
supported as a compound value. If the
ME supports several PDP types, the
parameter value ranges for each PDP
type are returned on a separate line.
supported as a compound value. If the
ME supports several PDP types, the
parameter value ranges for each PDP
type are returned on a separate line.