Motorola G24 Benutzerhandbuch
GPRS/EDGE
3-340
AT Commands Reference Manual
December 31, 2007
EDGE Commands
Note:
The following commands will be used only with G24 modules that support Edge.
+CGEQREQ, EDGE Quality of Service Profile (requested)
This command allows the TE to specify a EDGE Quality of Service Profile that is used when the
MT sends an Activate PDP Context Request message to the network.
MT sends an Activate PDP Context Request message to the network.
Command
Type
Syntax
Response/Action
Remarks
Set
+CGEQREQ=[<cid>
[,<Traffic class>
[,<Maximum bitrate
UL> [,<Maximum
bitrate DL>
[,<Guaranteed bitrate
UL> [,<Guaranteed
bitrate DL>
[,<Delivery order>
[,<Maximum SDU
size> [,<SDU error
ratio> [,<Residual bit
error ratio>
[,<Delivery of
erroneous SDUs>
[,<Transfer delay>
[,<Traffic handling
priority> ]]]]]]]]]]]]]
[,<Maximum bitrate
UL> [,<Maximum
bitrate DL>
[,<Guaranteed bitrate
UL> [,<Guaranteed
bitrate DL>
[,<Delivery order>
[,<Maximum SDU
size> [,<SDU error
ratio> [,<Residual bit
error ratio>
[,<Delivery of
erroneous SDUs>
[,<Transfer delay>
[,<Traffic handling
priority> ]]]]]]]]]]]]]
OK
or:
ERROR
The set command
specifies a profile for the
context identified by the
(local) context
identification parameter,
<cid>. The specified
profile will be stored in
the MT and will be sent to
the network only at
activation or MS-initiated
modification of the related
context. Since this is the
same parameter that is
used in the +CGDCONT
and +CGDSCONT
commands, the
+CGEQREQ command is
effectively an extension to
these commands. The
QoS profile consists of a
number of parameters,
each of which may be set
to a separate value. In
spite of this, not all
possible combinations are
allowed.
specifies a profile for the
context identified by the
(local) context
identification parameter,
<cid>. The specified
profile will be stored in
the MT and will be sent to
the network only at
activation or MS-initiated
modification of the related
context. Since this is the
same parameter that is
used in the +CGDCONT
and +CGDSCONT
commands, the
+CGEQREQ command is
effectively an extension to
these commands. The
QoS profile consists of a
number of parameters,
each of which may be set
to a separate value. In
spite of this, not all
possible combinations are
allowed.
.
A special form of the set
command, +CGEQREQ=
<cid> causes the
requested profile for
context number <cid> to
become undefined.
command, +CGEQREQ=
<cid> causes the
requested profile for
context number <cid> to
become undefined.