Motorola G24 Benutzerhandbuch
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-399
Example
AT+MIPFLUSH=2//Socket number 2 was previously opened using the +MIPOPEN command
+MIPFLUSH: 2
OK
AT+MIPFLUSH=5
ERROR
AT+MIPFLUSH?
+MIPFLUSH: 1 2
OK
+MIPRUDP, Receive Data from UDP Protocol Stack
This unsolicited event is sent by the G24 to the terminal when data is received from the UDP
protocol stack.
protocol stack.
Set Command Event
+MIPRUDP:<Source IP>,<Source Port><socket ID>,<Left>,<Data>
The following table shows the +MIPRUDP parameters.
Example
+MIPRUDP: 172.16.3.135,222,2,0,44444444
+MIPRTCP, Receive Data from TCP Protocol Stack
This unsolicited event is sent by the G24 to the terminal when data is received from the TCP
protocol stack.
protocol stack.
Note:
In case of SSL secured connection, the encryption increases the amount of data and SSL
protocol uses encrypted alerts, therefore the <Left> parameter shows gross encrypted
amount of data (including encrypted alert messages) still left in protocol stack, which is
greater than actual amount of decrypted data.
protocol uses encrypted alerts, therefore the <Left> parameter shows gross encrypted
amount of data (including encrypted alert messages) still left in protocol stack, which is
greater than actual amount of decrypted data.
Set Command Event
+MIPRTCP: <socket ID>,<Left>,<Data>
Table 3-268: +MIPRUDP Parameters
<Parameter>
Description
Source IP
IP of the source
Source Port
Port of the source
Socket ID
1,2,3,4 - Number of valid sockets.
Left
Size of received Data still left in protocol stack.
Data
Data string received with 0-F hexadecimal digits. String ends with a <CR>.