Motorola G24 Benutzerhandbuch

The following table shows the +FRS parameters.

This command causes the G24 to transmit data to the remote party using the modulation selected 
in <MOD>. The G24 sends the data stream received from the terminal without any framing.

The DLE character, (0x10), is used as a special character to precede command characters. The 
character pairs <DLE><command> are used to convey commands or status information between 
the terminal and the G24. 

Terminal to G24 streams (Encoding)

When the terminal needs to send a <DLE> character in the data stream, it sends two 

sequential <DLE> characters to the G24.

When the terminal needs to send two sequential <DLE> characters in the data stream, it 

sends the <DLE><SUB> characters instead.

When the terminal sends the terminator sequence <DLE> <ETX>, the data stream is 

terminated.

G24 to terminal streams (Decoding):

The terminal decodes the input stream and removes all character pairs beginning with 

<DLE>. 

The terminal recognizes <DLE><ETX> as the data stream terminator. 

The terminal recognizes and replaces <DLE><DLE> by a single <DLE> in the data stream. 

The terminal recognizes and replaces <DLE><SUB> by a single <DLE><DLE> in the data 

stream.

When the G24 receives the +FTM command, it immediately returns an OK result code. When the 
terminal receives the OK from the G24, it can start sending the data stream using the transparent 
data command encoding. When the G24 decodes the terminating sequence, it returns a 
CONNECT.

The duration of the silence, in 10 millisecond intervals.
0-255 Number of milliseconds.