Motorola G24 Benutzerhandbuch

The following sections describe UART flow control in the MUX.

G24 supports automatic UART hardware flow control.

Software flow control at the physical UART level is not supported in MUX.

The MUX feature supports software flow control per channel at basic mode, according to 3G TS 
27.010 V3.3.0.

There is no support for software flow control per channel at advanced mode.

Includes both sleep and wakeup services. This service will be supported in future 
versions.

Used to disconnect a DLC exclude control channel (DLCO).

Used to terminate multiplexer operation on the serial channel and resume GRLC 
operation (returns to PREMUX state).

Includes services at the MUX entity level and at the specific DLC level.

MUX Entity Level services (channel 0):
Test Service used to test the communication link between two MUX entities.

Specific DLC Level services (all DLC except 0):
1. A specific DLC HW modem status is reflected by logical (SW) means. A Modem 
Status Command (MSC) is used to control specific DLC modem signals, as a 
substitute for the HW lines in PREMUX. Initial values are expected to mirror the HW 
values in PREMUX.
Note: The MSC break signal, RTS and CTS are not supported.
2. "Non Supported Command" response: NSC frame

PN, RPN, RLS, SNC (27.010 options)