Mitsubishi Electronics MR-MC241 Benutzerhandbuch
7 - 26
7. AUXILIARY FUNCTION
7.8 Software reboot function
Through using the software reboot function, the host controller can restart the position board using software.
Perform the software reboot according to the following procedure. (Refer to the system data table for the
command/status signal.)
Perform the software reboot according to the following procedure. (Refer to the system data table for the
command/status signal.)
Turn on reboot
preparation signal (RBR)
Turn on execution of
reboot signal (RBS)
Start
Set reboot ID
No
Yes
Is the reboot
preparation OK?
(RBOK = ON?)
* Set reboot ID to 1EA5.
Finish
sscReboot function
POINT
When reboot preparation is turned on, it becomes a forced stop status.
If an erroneous reboot ID is set and reboot preparation turned on or execution
of reboot turned on without performing reboot preparation, a reboot
preparation error occurs. If a reboot preparation error occurs, turn off reboot
preparation and execution of reboot and restart the process from the
beginning.
preparation error occurs. If a reboot preparation error occurs, turn off reboot
preparation and execution of reboot and restart the process from the
beginning.
API LIBRARY
Use the sscReboot function to perform software reboot.