Mitsubishi Electronics MR-MC241 Benutzerhandbuch
10 - 41
10. TABLE MAP
10.7 Servo parameter change number
When parameter settings within the servo amplifier are changed using the auto tuning function or parameter
changes using MR Configurator2 (set up software), the bit corresponding to the servo parameter number that
was changed is turned on to notify concerning which parameter number was changed (in units of 16). To
identify the changed parameter, check the servo parameter change number (monitor No.0590 to 05B7)
corresponding to the bit which is turned on. Refer to Section 7.2 for more information.
changes using MR Configurator2 (set up software), the bit corresponding to the servo parameter number that
was changed is turned on to notify concerning which parameter number was changed (in units of 16). To
identify the changed parameter, check the servo parameter change number (monitor No.0590 to 05B7)
corresponding to the bit which is turned on. Refer to Section 7.2 for more information.