3M 2273M Benutzerhandbuch

78-8130-6150-0 Rev G 

57

2.  Clamp the 3M

™

 Dyna-Coupler around the cable or both the tip and ring of a pair. 

3.  Press and hold off [T-1] to perform a battery check.
4.  Press on: Ohm-meter/Fault Locate/Tone [T-2] three times to set the transmitter to 

Tone mode.

 

− The indicator flag will light in the Digital Display [T-4] under the Tone icon.

5.  Press Output Level [T-5] for high or maximum output power level.

 

− The indicator flag will light in the Digital Display [T-4] above the Output Level 

icon when in high output power level and flash when in maximum output power 

level.

 

− The Digital Display [T-4] will alternately flash between 577 and 200K.

2. Receiver Setup

1.  Press On/Off (Power) [1] to power the receiver on.
2.  Press Locate/OK [5].
3.  Press Tone/Ext [SK] to select Tone mode.
4.  Connect a second coupler to the receiver’s External Jack [14] ([13] on 2250M) 

using the Earth Contact Frame cable (4 ft. (1.2 m) cable) or another coupler cable.

5.  Press Freq [SK Toggle] to select the highest transmitter frequency (200K).
6.  Check the first cable in the group by clamping the coupler around the cable. Make 

7.  Press Gain [4] down and observe the numerical Signal Strength [10].
8.  Remember the signal strength value and continue by clamping the coupler around 

the next cable in the group.

 

− If the Signal Strength [10] is greater than the previous observation, press Gain 

[4] down.

 

− If the Signal Strength [10] is less than before, ignore it.

 

− After checking all the cables in the group, the cable with the highest Signal 

Strength [10] reading is the target cable.

Menu [6] + >>More [SK:4] + Help [SK:8]

The help display contains basic information about the unit and its operation. It is 

designed to be a quick reference guide.
•  Press the double up/down arrows [SK] to navigate between sections.

 

− The single up/down arrows [SK] will scroll the display line by line.