3M 530 Benutzerhandbuch

78-8135-7466-8-B

1.0 Kit Contents

Note: Visually inspect all components. If any component is missing or appears damaged, do not install.

Call 3M customer service at 1-800-426-8688 for a replacement product.
1.1

Kit Contents SLiC 530/533/733-2 Port 0.61 Cable

Entry Bracket 80-6113-2344-7
A.  Cable Addition Bracket Assembly (1)
B.  Cap
C.  Multi-port Grommet (1)
D.  Hose Clamp (1)
E.  Pair Saver
F.  3M

™

Scotchlok

™

Shield Bond Connector 4460

with LSM Clamp (2)

G.  10-32 UNF Flange Nut (2)
H.  Lubricant (1)
I.  Instruction Manual 78-0013-2695-4 (Not Shown)

F, G

1.2

Kit Contents SLiC 530/533/733-2 Port-MSM 0.61

Cable Entry Bracket 80-6113-8403-5
A.  Cable Addition Bracket Assembly (1)
B.  Cap
C.  Multi-port Grommet (1)
D.  Hose Clamp (1)
E.  Pair Saver
F.  3M

™

Scotchlok

™

Shield Bond Connector 4460

with LSM Clamp (2)

G.  10-32 UNF Flange Nut (2)
H.  Lubricant (1)
I.  Instruction Manual 78-8128-0289-6 (Not Shown)

F, G

2.0 Cable Preparations

2.1

Per company practice, remove sufficient cable

jacketing to allow for slack storage and splicing needs

(approximately 5 feet).

2.2

Trim central strength members on both cables

approximately 3" (76 mm) from the end of the cable

jacket.

Note: When using ribbon fiber cable, leave a minimum of

2" (50 mm) of central tube.

2.3

Insert cables into the multi-port grommet so that

1.25" to 1.75" (32–45 mm) of cable jacketing is

exposed past the inside edge of the grommet.

Note: A small amount of lubricant provided in the kit

may be placed on the leading edge of the cable to ease

installation into the grommet.

Note: Place and tighten a cable tie around the grommet

or you may also place a couple of wraps of Scotch

Linerless Rubber Splicing Tape 130C around cable to

provide a better seal.

Note: Carefully follow safety, health and environmental

information given on product label or the Materials

Safety Data Sheet for the lubricant.

1.25"–1.75"

(32–45 mm)

3" (76 mm)