Panasonic AJ-HPM110E Benutzerhandbuch

Seite von 168
Introduction: Recording, Playback and P2 Card Handling
35
 Intr
od
uc
tio
n
◆ NOTE: 
• Detailed check of P2 card status is possible. Refer to “Checking 
A continuous recording that is longer than the durations given 
below when an 8 GB P2 card is used in this unit will result in 
the automatic division of the recording into different clips. 
Even so, the recordings on the two clips can be handled as a 
single clip in thumbnail operations (display, delete, repair, 
copy, etc.) on a P2 device. 
Such a recording may be handled as separate clips in 
nonlinear editing software or on PCs. 
* Available when the optional AVC-Intra Codec board AJ-
YBX200G is installed
When two or more P2 card slots contain cards, the unit 
records continuously by switching cards. When available 
space on the P2 cards has been used up, recording 
continues from the first card overwriting previously recorded 
loop recording. 
To use this function, set LOOP REC in the setup menu to “ON”.
➝For details, refer to “Setup Menu No. 041 (LOOP REC)” 
P2 Card Access LEDs and P2 Card Status
P2 card access LED
P2 card status
Green light
Reading and writing are possible.
Orange light
Reading and writing are possible. 
The card is selected for recording 
(including loop recording).
Flashes orange
Reading and writing are possible.
◆ NOTE:
• Do not turn the unit off or remove a 
P2 card during recording or when 
the LED flashes orange.
Flashes rapidly in 
orange
P2 card is being recognized.
Flashes green
The P2 card has no remaining 
memory capacity. Available only 
for reading.
The write-protection switch on the 
P2 card is set to [PROTECT]. 
Available only for reading.
Off
The P2 card is not properly 
formatted. Reformat the card on 
this unit. 
This card cannot be used in this 
unit. Replace the card.
No P2 card has been inserted.
The unit is in the USB DEVICE 
mode and is not accessing the P2 
card. 
Dividing clips over 4 GB in length
Recording format
Recording duration
DVCPRO HD
Approx. 5 min.
DVCPRO50
Approx. 10 min.
DVCPRO/DV
Approx. 20 min.
AVC-Intra50*
Approx. 10 min.
AVC-Intra100*
Approx. 5 min.
LOOP REC Function
B
A
C
B
C
D
Card 1 
Card 2 
Card 3
Unrecorded area Recorded area
State of 
cards prior 
to loop 
recording
Recording starts
Recording 
cycle 1
Recording 
cycle 2
Loop recording records the unrecorded areas (A 
 B  C 
order) on the P2 cards. When all unrecorded areas on the 
cards have been recorded, recording continues by overwriting 
previous loop recording in area A (D).