Panasonic AJ-HPM110E Benutzerhandbuch

Seite von 168
Using Play List: Overwrite Editing of Play Lists
89
 Us
ing P
la
y
 Li
st
1
Press the PLAY button in the play list screen to 
display video. 
2
Press the IN (OUT) + GOTO buttons or operation 
buttons and press the IN (OUT) + ENTRY buttons 
where the revision will be made to reregister. 
You can perform fine adjustment (trimming) by hold down 
the IN (OUT) button and pressing the TRIM (+/–) button. 
1
Hold down the SHIFT button in the play list screen 
and press the IN (OUT) button. 
2
The screen for revising IN/OUT points appears in P 
IN (P OUT) 
➝ R IN (R OUT) ➝ OFF order. 
3
Press the TRIM+/– button to trim. 
◆ NOTE:
• The RESET button clears registered points. 
• Holding down the button enables fast-forwarding.
4
Press the ENTRY button to finalize the change. 
Or press the SET button to finalize. 
Use the following steps to preview overwritten area (in orange) 
to check audio and video. 
1
Hold down the SHIFT button and press the PLAY 
button
Playback starts 3 seconds prior to the overwritten area 
and 1 second after the area. 
◆ NOTE:
• Press the STOP button to stop previewing. 
• Overwrite edited events in unfinalized status (all events if more 
than one) are played back regardless of pointer location. 
• The sound can be adjusted only during a preview. 
2
Use the playback volume to adjust playback level 
during preview. 
• The playback level is fixed at the level set during 
preview. 
• Review and play list playback plays back events at the 
imported sound volume. 
◆ NOTE:
• When there are multiple events, all events are played back at 
the same sound volume. 
• The same sound volume is used in an event and cannot be 
changed. 
Use the steps below to finalize overwrite edited events in 
unfinalized status and return to normal event operation. 
1
When there are any unfinalized events, press the 
REC button. 
2
This finalizes the event and changes the orange of 
the unfinalized event to white. 
◆ NOTE:
• When an event is not to be registered, clear the IN or OUT point 
or use CANCEL (hold down the SHIFT button and press the EXIT 
button) to clear all IN and OUT points. 
• Exiting the play list by pressing the PLAYLIST button clears all 
unfinalized events and all IN and OUT points. 
• Use the following steps to change channel settings after 
finalizing an event. 
1. Select an event or multiple events to edit. 
2. Choose [SETTING] – [AUDIO CH] from the menu to change 
the channel setting.
3. Choose [OPERATION] – [EDIT AUDIO CH] from the menu. 
4. Select YES. 
The recalling method can also be used.
Revising R IN/R OUT while Viewing Video
Revising in the Play List Screen
Previewing and Adjusting Sound Volume
Finalizing Overwrite Editing