Hitachi VT-F372A Benutzerhandbuch
Getting Started (Controls)
23
TRACKING Lets you fine tune the picture.
0 to 9 Number buttons used in on-screen programming. Can also be used to change
channels. (Simply press 2 or 3 digits for the channel you want - such as 0 and 6 for
channel 6, or 100/ENT and 2 and 4 for channel 124.)
channels. (Simply press 2 or 3 digits for the channel you want - such as 0 and 6 for
channel 6, or 100/ENT and 2 and 4 for channel 124.)
VCR/TV Switches between viewing through the VCR and not viewing through the VCR.
LIGHT Illuminates key function buttons for a few seconds.
When the Remote Doesn't Work Right
Check out these possibilities:
Low Battery
If the remote is not working even at close range, try putting in two fresh AA batteries.
If the remote is not working even at close range, try putting in two fresh AA batteries.
Objects in the Way
There may be objects between the remote and the VCR - for instance, a stack of books
on the coffee table, your 2-year-old, the dog. Hold the remote so that it points at the
VCR with nothing in the way.
There may be objects between the remote and the VCR - for instance, a stack of books
on the coffee table, your 2-year-old, the dog. Hold the remote so that it points at the
VCR with nothing in the way.
Set to Wrong Device
It may be set to VCR2 when you're trying to control VCR1. To confirm that this is the
case, try pressing VCR2 and a function button (like channel up or down). If the remote
works now, you know that it's set to VCR2. To reset it to VCR1, refer to the on-screen
Initial Setup options.
It may be set to VCR2 when you're trying to control VCR1. To confirm that this is the
case, try pressing VCR2 and a function button (like channel up or down). If the remote
works now, you know that it's set to VCR2. To reset it to VCR1, refer to the on-screen
Initial Setup options.
If You Just Want to Watch TV
For normal TV viewing, you do not need to disconnect the VCR. When the TV and VCR
are already on, press POWER on the remote control. The VCR will shut off, but the TV
will stay on.
are already on, press POWER on the remote control. The VCR will shut off, but the TV
will stay on.
If you are recording on the VCR but want to watch a different channel on the TV, press
the VCR/TV button to switch back and forth between the TV channel and the recording
channel.
the VCR/TV button to switch back and forth between the TV channel and the recording
channel.