Snapper Zero Turning Z-Riding Benutzerhandbuch

B. Attach roll bar to side bars, securing with two 1/2-
13 x 3-3/4” hex bolts and lock nuts through the rear
hinge holes. See Figure 4.  NOTE: Slip stop brackets
over hinges before installing hardware.  See Figure 4.  
C. Raise roll bar to fully upright position, aligning
locking holes in roll bar with corresponding holes in
side bars. Insert locking pin through each forward
hole, and secure with connected bridge pin. Install
plastic knobs into threaded holes in front of roll bar,
and tighten securely. See Figure 4.
D. Tighten hardware securing side bars to frame
brackets, torquing to 60-70 ft-lbs. Tighten roll bar
hardware as well; however, leave loose enough so
that roll bar folds and raises easily.
E. Install anti-vibration bolts into sides of frame
brackets, tightening securely.  See Figure 3.

STEP 6:  Check date on battery label. See Figure 5.  If
battery is placed into service after date shown on label,
battery will have to be charged:

A.  Remove battery from battery compartment before
charging.
B. Place battery in a well ventilated area on a level non-
concrete surface.
C.  Charge battery at 6-10 amps for 1 hour to bring
battery to full charge.

STEP 7:  Install battery into power unit. NOTE:  In order to
raise operator seat to access battery compartment, seat
must be in rearmost position.
STEP 8: Both bolts are already installed on both terminals.
Connect positive (+) cable (red) first, from wiring harness to
positive terminal (+) on battery and secure with nut
provided in hardware bag. Connect negative (-) cable
(black) last, to negative terminal (-) on battery and secure
with nut also provided. See Figure 5. Apply a small amount
of grease over terminals to prevent corrosion.  

STEP 9:  Take the necessary precautions when handling
fuel. Fill the fuel tank with clean fuel. Check oil and add oil if
needed as stated in Engine Owners Manual. Move fuel tank
selector valve handle to the desired fuel tank.