Turbosound NuQ SERIES Benutzerhandbuch

 

 

Non-powered NuQ cabinets can be ceiling mounted using OmniMount™ ceiling brackets 
from the 60 series and 120 series ranges. The brackets attach to the rear of the cabinet 
and allow a range of angle adjustment. To install a cabinet using OmniMount ceiling 
brackets: 

• 

Remove the blanking screws from the rear panel of the loudspeaker (there are 

two M6 hex countersunk screws on the NuQ-8 and NuQ-10, and four M6 hex 
countersunk on the NuQ-12 and NuQ-15). 

• 

Mount the bracket to the ceiling using suitable fixings. 

• 

Offer up the loudspeaker using suitable lifting equipment and attach the speaker 

plate to the rigging points on the rear of the loudspeaker. 

• 

Angle as necessary and tighten all fixings. 

NuQ series loudspeakers offer two choices of dispersion pattern, and this facility gives 
considerable flexibility of coverage when assembling small loudspeaker arrays. By 
rotating the Converging Elliptical Waveguides within the cabinet it is possible to obtain 
either wide horizontal coverage or narrow horizontal coverage. The table below shows 
the possible dispersion options for each model. 

Model 

NuQ-8 

NuQ-10 

NuQ-12 

NuQ-15 

Factory-supplied 

100°H x 60°V 

100°H x 60°V 

80°H x 50°V 

80°H x 50°V 

HF horn rotated 

60°H x 100°V 

60°H x 100°V 

50°H x 80°V 

50°H x 80°V 

Where ceiling height is limited or for other aesthetic reasons it may be desirable to mount 
cabinets horizontally. The NuQ-SB horizontal 
swivel bracket is used for this purpose, and can 
be fixed directly to a ceilings, or truss mounted 
using the SC-01 scaffold clamp. The swivel 
bracket is attached to the M10 rigging point at the 
top of the cabinet and to the pole mount socket at 
the bottom. In order to maintain a wide horizontal 
coverage pattern when flying the cabinet 
horizontally the high frequency horn should be 
rotated through 90°. For instructions on rotating 
the horn please refer to the servicing section of