SDI Technologies iP27 Benutzerhandbuch
5
Using The Remote Control Unit
Install/Replace the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control
stops operating or its range seems reduced, replace the battery with a new one.
1. The battery door is located on the back end of the unit.
2. Slide the battery door to release the battery door latch and remove the battery door.
3. Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and – side of
1. The battery door is located on the back end of the unit.
2. Slide the battery door to release the battery door latch and remove the battery door.
3. Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and – side of
the battery) is correct.
4. Replace the battery compartment door back in the remote control.
NOTE: PLEASE DISCARD BATTERIES PROPERLY
Operating the remote control
The Remote Control controls basic functions on the iP27 and certain iPhone/iPod functions when the iPhone/iPod is docked
in the iP27. For best results, aim remote control towards the remote sensor by the lower right corner of the display.
Move the Switch to Remote position to enable the remote control.
6
Turns iP27 OFF or resets alarm when alarm is sounding
Toggles sound ON or OFF
Turn EXB sound enhancement ON or OFF
Selects Sleep Time function
Snooze mode when alarm sounds, otherwise dims display
Skip to previous or next track when iPod is playing, or
hold to scan current playing track.
hold to scan current playing track.
Install/Replace Backup Battery
The iP27 uses a backup battery system to provide continuous alarm operation and
The iP27 uses a backup battery system to provide continuous alarm operation and
clock settings in the event of a power failure. If the Backup Battery Low Icon located
on the left of the display is flashing, it is time to replace the backup battery. Please
make sure the AC adaptor is connected, otherwise all settings may be lost during
battery replacement.
Open the battery compartment cover located on the bottom of the unit in the left
Open the battery compartment cover located on the bottom of the unit in the left
battery compartment. Insert 1 “CR2032” battery as indicated. Replace battery
compartment covers.
Replacing iP27 Backup Battery
Battery install for
Clock display back up
The iP27 uses 4 “AA” (LR6) batteries for portable playing. If sound becomes weak
or distorted while operating on batteries, it’s time to replace the batteries.The iP27
will not charge your iPhone or iPod while operating on batteries.
• Open the battery compartment covers located on the bottom of the unit.
• Insert 2 AA (LR6) batteries in each compartment as indicated, making sure the
• Open the battery compartment covers located on the bottom of the unit.
• Insert 2 AA (LR6) batteries in each compartment as indicated, making sure the
polarity (+ and -) matches the diagram.
• Replace battery compartment covers.
Batteries information:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium)
• Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium)
batteries.
Install/Replace Batteries for Portable Use
Volume Buttons raise and lower volume on the unit.
alm. reset
OFF
sleep
mute
snooze
IP27BR IB
Selects iPhone/iPod and plays track. In play mode, press to pause