Blomberg DV16540NBL00 Benutzerhandbuch

23 - EN

Problem

Cause

Explanation / Solution

Drying process 

takes too long. 

 Lint filter may not have been 

cleaned.

* Clean the lint filter.

* Meshes of the filter may be clogged. 

Wash with water.

Dryer does not 

switch on or the 

program does 

not start. Dryer 

does not start 

when set.

* It may not plugged in.

* The loading door may be ajar.

* Program may not be set or the 

“Start/Pause/Cancel” button may 

not have been pressed.

* “Childproof lock” may be 

activated.

* The condenser cover on models 

with a condenser may not be 

closed securely.

* Make sure that the dryer is plugged 

in.

* Make sure the loading door is 

properly closed.

* Make sure the program has been set 

and it is not in “Pause” mode.

* Deactivate the childproof lock.

* Make sure the condenser cover and 

the red lock is closed securely.

Program is 

interrupted for 

no reason.

* The loading door may be ajar.

* Electricity may be cut off.

* Make sure the loading door is 

properly closed.

* Press the “Start/Pause/Cancel” 

button to start the program.

Laundry has 

shrunk, become 

felted or has 

deteriorated.

* A program not suitable for the 

laundry type might have been 

used.

* Dry only the laundry which is suitable 

for drying in the dryer. First check the 

labels on the clothes.

* Select a program a suitable low 

temperature setting for the laundry 

type to dry the clothes.

Drum light does 

not come on.

(for models 

equipped with a 

lamp)

* The dryer may not have been 

started using the On/Off button.

* Bulb may have burned out.

* Make sure the dryer is On.

* Call the authorized service to replace 

the bulb.

“End / 

Anticrease” LED 

flashes.

* The 2-hour anti creasing 

program to prevent laundry 

from wrinkling may have been 

activated.

* Turn off the dryer and take the 

laundry out of the dryer.

“End / 

Anticrease” LED 

is on.

* Program has come to an end.

* Turn off the dryerand take the laundry 

out of the dryer.

“Filter cleaning” 

LED flashes.

* Lint filter may not have been 

cleaned.

* Clean the lint filter.

The “Drying” 

LED flashes.

* A heat sensor failure has 

occurred. dryer ends the program 

without heating.

* Turn off the dryer and remove the 

laundry. Call the authorized service.

For products equipped with a condenser

“Water tank” 

warning LED on.

* Water tank may be full.

* Anti-creasing program might be 

running.

* Drain the water from  the water tank.

“Condenser 

cleaning” LED 

on.

* Condenser may not have been 

cleaned.

* Clean the condenser.

A

 Call an authorized service if the problem persists.