Blomberg DV16540NBL00 Benutzerhandbuch

Seite von 24
8 - EN
A WARNING
 
- Risk of fire
•  The clothes dryer (“appliance‘) installation
must be performed by a qualified installer.
•  Install the appliance according to the
manufacturer’s instructions and local codes.
•  Do not install a clothes dryer with flexible
plastic venting materials. If flexible metal 
(foil type) duct is installed, it must be of a
specific type identified by the appliance 
manufacturer as suitable for use with 
clothes dryers. Flexible venting materials are 
known to collapse, be easily crushed, and 
trap lint. These conditions will obstruct the 
clothes dryer’s airflow and increase the risk 
of fire.
A
 To reduce the risk of severe injury or 
death, follow all installation instructions.
SAVE THESE INSTRUCTIONS 
Electrical connection
Connect the appliance to a grounded outlet 
protected by a fuse or circuit breaker of 
suitable capacity.
3-Wire Electrical Connection 
If your receptacle is a 3-wire receptacle as 
shown below, you must obtain a 3-wire dryer 
cord. A dryer cord can usually be found at 
your local hardware supply, electrical supply or 
home center. Cord should have closed loop or 
upturned end wire terminating connectors.
A
 If the dryer is installed in a mobile home, 
recreational vehicles, new branch-circuit 
installations or in areas where local codes do 
not permit grounding, only a 4-wire power 
supply cord shall be used.
To change the cord:
1. Make sure that the dryer is not plugged into 
any power outlet.
B
 DO NOT plug end of dryer power cord 
into a live receptacle before connecting dryer 
power cord to dryer terminals and closing 
junction/splitter box as described below.
B
 DO NOT repair old power supply cords. 
Power cord must be changed only by a
qualified person. There is a risk of electric 
shock!
2. Remove the screw from the cover of the
junction box located at the top rear of the 
dryer.
3. Remove the red, white and black wire from
the terminal block.
4. Remove the green ground wire from the
ground terminal.
5. Loosen the strain relief clamp holding the 
4-wire cable.
6. Thread the 4-wire cable out through the 
strain relief clamp.
7. Thread the new 3-wire dryer cord through 
the strain relief clamp.
3- wire receptacle
( 10-30R)
Typical 3- Wire Dryer Cord 240V/30 amp
NEMA 10-30 Type SRDT
3
  Installation Instructions
 
4-wire receptacle  
(14 -30R) 
 
3-wire receptacle  
(10 -30R) 
 
If yo u have 3-wir e receptacle, like  
this , a 3-wire dryer cord  mu st be 
purc hased locall y. 
 
Dryer shipped with cord to fit this
type 4 -wire receptacle