Beko DCU 8230 Benutzerhandbuch

Seite von 24
19 EN
7
  Maintenance and cleaning
Filter Cartridge / Door Inner 
Surface
Lint and fibres released from the laundry to 
the air during the drying cycle are collected in 
the “Filter Cartridge”. 
C
Such fibre and lint are generally formed 
during wearing and washing.
C
  Always clean the filter and the inner 
surfaces of the cover after each drying 
process.
C
  You can clean the filter and filter area by 
vacuum cleaner.
To clean the filter:
1.  Open the loading door.
2.  Remove the cover filter by pulling it up 
and open the filter.
3.  Clean lint, fibre, and cotton raveling by 
hand or with a soft piece of cloth. 
4.  Close the filter and place it back into its
seat.
Clogging may arise on the filter surface 
after using your machine for some time; 
if this occurs, wash the filter with water 
and dry it before using again. 
Clean the entire inner surface of the 
cover and door gasket.
Sensor 
There are humidity sensors in your dryer that 
detect whether the laundry is dry or not.
To clean the sensor:
1.  Open the loading door of the dryer.
2.  Allow the machine to cool down if drying 
has been carried out.
3.  Wipe the metal sensors with a soft cloth, 
dampened with vinegar and dry them.
C
  Clean metal sensors 4 times a year.
A
 Never use solvents, cleaning agents 
or similar substances when cleaning 
since these materials can cause fire and 
explosion! 
Water tank;
The moisture in the damp laundry is taken 
from the laundry and condens ed. Drain the 
water tank after each drying cycle or during 
drying when “Water tank” warning light turns 
on.
A
 Condensed water is not drinkable!
A
 Never take out the water tank when the 
programme is running!
-  Inside the drawer on the panel
-  Behind the kick plate cover
If you forget to drain the water tank, your 
dryer will stop during the following drying 
cycles when the water tank is full and 
the “Water tank” warning light will turn 
on. If this is the case, press the “Start/
Pause/Cancel” button to resume the 
drying cycle after draining the water 
tank.
To drain the water tank:
1.  Drain the water  as shown on the 
picturre .