Beko DCU 8230 Benutzerhandbuch

6 EN

This section includes safety information that 

will help protection from risks of personal 

injuries or materialistic damages. Failure 

to follow these instructions shall cause 

any warranty and reliability commitment to 

become void.

•  Never place the machine on a carpet-

covered floor, otherwise, lack of airflow 

beneath the machine may cause 

electrical parts to overheat. This will 

cause problems with your machine.

•  If the power cable or mains plug is 

damaged, you must call Authorised 

Service Agent for repair.

•  The product should not be plugged 

in during installation, maintenance 

and repair works. Such works should 

always be made by the technical 

service. Manufacturer shall not be held 

responsible for damages arising from 

processes carried out by unauthorised 

persons.

•  Connect the product to a grounded 

outlet protected by a fuse of suitable 

capacity as stated in the technical 

specifications table.

•  Operate your product at temperatures 

between +5°C and +35°C.

•  Do not use electrical devices in the 

product.

•  Do not connect the air exit of the product 

to the chimney holes which are used 

for the exhaust fumes of the devices 

operating with gas or other types of fuel.

•  You must provide enough ventilation 

in order to prevent gases exiting from 

devices operating with other types of 

fuels including the naked flame from 

accumulating in the room due to the 

back fire effect.

•  Always clean the lint filter before or after 

each loading.

•  Never operate your dryer without the lint 

filter installed.

•  Do not allow fibre, dust and dirt 

accumulation around the exhaust exit 

and at adjacent areas.

•  Power cable plug must be within easy 

reach after installation.

•  Do not use extension cords, multi-plugs 

or adaptors to connect the dryer to 

power supply in order to decrease the 

risk of electric shock.

•  Do not make any changes on the plug 

supplied with the product. If it is not 

compatible with the socket, have a 

qualified electrician change the socket 

with a suitable one.

•  Items cleaned or washed with gasoil/

fuel oil, dry-laundry solvents and other 

combustible or explosive materials as 

well as the items that are contaminated 

or spotted with such materials should 

not be dried in the product since they 

emit flammable or explosive vapor.

•  Do not dry items cleaned with industrial 

chemicals in the dryer.

•  Do not dry unwashed items in the dryer.

•  Items soiled with cooking oils, acetone, 

alcohol, fuel oil, kerosene, stain remover, 

turpentine, paraffin and paraffin removers 

must be washed in hot water with plenty 

of detergent before being dried in the 

dryer.

•  Garments or pillows bolstered with 

rubber foam (latex foam), shower 

bonnets, water resistant textiles, 

materials with rubber reinforcement and 

rubber foam pads should not be dried in 

the dryer.

•  Do not use fabric softeners and 

anti-static products unless they are 

recommended by the manufacturers of 

the fabric softener or the product.

•  This product must be earthed. 

Grounding installation decreases the risk 

of electric shock by opening a path with 

low resistance for the electricity flow in 

case of a malfunction or failure. Power 

cable of this product is equipped with 

a conductor and a grounding plug that 

allows for grounding the product. This 

plug must be installed appropriately and 

inserted into a socket which is grounded 

in accordance with the local laws and 

regulations.

•  Do not install the product behind a door 

with a lock, sliding door or a door that 

has a hinge against the hinge of the 

dryer.

•  Do not install or leave this product 

in places where it will be exposed to 

outdoor conditions.

•  Do not tamper with the controls.

•  Do not perform any repair or part 

replacing procedures on the product 

even if you know or have the ability to 

perform unless it is clearly suggested 

in the operating instructions or the