HUGFEN C147-3 Benutzerhandbuch
Health and Safety
Due regard shall be given to observing safe procedures when working with or on the equipment. It is the
responsibility of the Installer / Operator / Customer to ensure that the “Health and Safety at Work Act (1974)”
and Normal Safe Working Procedures are adhered to at all times.
responsibility of the Installer / Operator / Customer to ensure that the “Health and Safety at Work Act (1974)”
and Normal Safe Working Procedures are adhered to at all times.
With reference to the "Control of Substances Hazardous to Health Regulations 1988 (COSHH)” the following
paragraphs have been extracted from Denco’s letter responding to information requested
paragraphs have been extracted from Denco’s letter responding to information requested
“However, certain substances contained within materials used in the manufacture of our units could be
hazardous when released, if the unit is misused, abused or maintained by unskilled labour.
hazardous when released, if the unit is misused, abused or maintained by unskilled labour.
Fumes would be released if pipework or slab foam insulation (Armaflex or similar), electrical insulation or vinyl
coatings were exposed to naked flame. It will be, therefore, that no naked flame should be applied to any of the
above mentioned substances, nor to print, rubber or plastic parts.
coatings were exposed to naked flame. It will be, therefore, that no naked flame should be applied to any of the
above mentioned substances, nor to print, rubber or plastic parts.
Light oil is applied to some bare metal parts as a protective coating and this could cause dermatic reaction to
sensitive skin.
sensitive skin.
Refrigerants contain hydrofluorocarbons (HFC’s). Glycol/water mix is used during manufacture but drained
before delivery. The quantities in use are minimal but care should be taken in disposal.
before delivery. The quantities in use are minimal but care should be taken in disposal.
We trust that this information is sufficient but should you require further information regarding our products or
maintenance service, please contact our sales department.”
maintenance service, please contact our sales department.”
Machine Card
In order to comply with BS EN 378-2:2000 “Refrigeration Systems and Heat Pumps – Safety and Environmental
Requirements”, an adequately protected card shall be situated near the operating site and must be clearly
readable. The card shall at least contain the following information:
Requirements”, an adequately protected card shall be situated near the operating site and must be clearly
readable. The card shall at least contain the following information:
1)
Name, address and telephone number of the installer, his service department, or the person responsible
for the refrigeration and the addresses and telephone numbers of the Fire Department, Police, Hospitals
and Burns Centres
for the refrigeration and the addresses and telephone numbers of the Fire Department, Police, Hospitals
and Burns Centres
2)
The refrigerant is R134a or R407C (refer to Technical Data Table)
3)
To shut down the Compressed Air Dryer in an emergency, switch off the unit using the ON/OFF isolating
switch on the front panel. The mains supply to the Dryer should be isolated at the mains isolator.
switch on the front panel. The mains supply to the Dryer should be isolated at the mains isolator.
4)
Maximum Allowable Pressures
Compressed Air
13 barg
5)
Flammability Limits in Air
NONE