Pentair Wide Angle Lens Merkblatt

®

We recommend that all FIBERworks lens assemblies be installed by trained and certified FIBERworks

dealers only

.

If you have any questions please call our service hot line, Monday through Friday,

 7:30 a.m. to 4:30 p.m., at (800) 831-7133

•

 FIBERworks lens housings are installed the same way water return fittings are installed.

•

 Use only Pentair Pool Products’

FIBERworks lens housings.  Other fittings
will not adequately seal conduit from pool
water.

•

 Cut the conduit back as shown in the

adjacent figure.  Dimension “a” should be
one inch (1”) for a FIBERworks Standard
Gunite housing, and one and a half inches
(1½”) for a FIBERworks Invisible Gunite
housing.

•

 Every lens assembly and preOptifused cable assembly now comes with a standard and wide angle

lens.  See lens assembly drawing to identify different lens types.  Use the table below to select the
appropriate lens for your application.

Lens Position

Lens

Type

Shallow End

Deep End

All Side Wall

Shadow Filler

Spa

Standard

X

Wide Angle

X

X

X

X

•

 Positioning on the pool/spa wall is the same for both lens types.  Follow the recommendations in

the Photon Generator Installation and Service Manual for proper lens positioning.

•

 DO NOT use any gel on the wide angle lens.  This will inhibit the light dispersion capabilities of

the lens.  PreOptifused cable assemblies come with the standard lens and Optifusion gel.  Wipe
excess gel off of cable face with a clean cloth before installing the wide angle lens.

•

 

A new lens tightening tool with longer pins (p/n 21006500) will be required to install the wide
angle lens

.

DO NOT use excessive glue.  Excess glue can overflow onto the o-ring sealing surface.

Gunite cutback - 1 ¼”

a

Plaster surface

Conduit

To Photon
Generator

Gunite

4 in.