JVC LYT0596-001A Betriebsanweisung
14
EN
2 5
90 min
89 min
3 min
2 min
1 min
0 min
min
180
°
90
°
BR I GHT –
+
PL
AY
O
FF
RECORDING
Basic Recording For Video
Tally lamp
(lights while recording
is in progress)
(lights while recording
is in progress)
Lock Button
Tape remaining
time indicator
(Approximate)
time indicator
(Approximate)
(Now calculating)
(Blinking)
(Blinking)
(Blinking)
Display
MENU/
BRIGHT Wheel
Power Switch
PUSH OPEN Button
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
below. If not, do so before continuing.
●
Power (
pg. 6)
●
Grip Adjustment (
pg. 8)
●
Viewfinder Adjustment (
pg. 8)
●
Load A Cassette (
pg. 10)
●
Recording Mode Setting (
pg. 11)
1
Press in the tabs on the lens cap to remove it. Press
PUSH OPEN, open the LCD monitor and set the
VIDEO/DSC Switch to “VIDEO”.
PUSH OPEN, open the LCD monitor and set the
VIDEO/DSC Switch to “VIDEO”.
2
Set the Power Switch to “
” or “
” while pressing
down the Lock Button located on the switch.
Shooting while using the LCD monitor:
Make sure
the LCD monitor is fully open. Tilt it upward/
downward for best viewability.
downward for best viewability.
Shooting while using the viewfinder:
Close the LCD
monitor.
•The power lamp lights and the camcorder enters the
Record-Standby mode. “PAUSE” is displayed.
3
Press the Recording Start/Stop Button. “
” appears
while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
To Adjust The Brightness Of The Display
.... rotate MENU/BRIGHT until the bright level indicator
on the display moves and the appropriate brightness is
reached.
reached.
•If you are using the GR-DVL800, it is also possible to
adjust the brightness of the viewfinder by closing the
LCD monitor and adjusting as described above.
LCD monitor and adjusting as described above.
During
shooting
Power lamp
Recording
Start/Stop Button
Start/Stop Button
VIDEO/DSC Switch